BlueRhino GCT1304W Manual do Proprietário - Página 3
Procurar online ou descarregar pdf Manual do Proprietário para Fogão BlueRhino GCT1304W. BlueRhino GCT1304W 13 páginas. Outdoor lp gas camp stove
Imprimir páginaW Storage of this camp stove indoors
is permissible only if the tank is
disconnected, removed from this camp
stove and properly stored outdoors.
W Do NOT attempt to disconnect the gas
regulator from the tank or any gas fitting
while this camp stove is in use.
W Disconnect LP gas tank when not in use.
W Always use your camp stove on a hard,
non-combustable, level surface. An asphalt
or blacktop surface may not be acceptable
for this purpose.
W Do NOT use directly on wooden decks or
wooden picnic tables.
W Keep all electrical cords away from a hot
camp stove.
W This camp stove is not intended for
and should never be used as a heater.
TOXIC fumes can accumulate and cause
asphyxiation.
W After a period of storage and/or nonuse,
check for leaks and burner obstructions.
W Always use a meat thermometer to ensure
food is cooked to a safe temperature.
W Never cover entire cooking area with
aluminum foil.
W Use protective gloves when assembling
this product.
W Do NOT force parts together as this can
result in personal injury or damage to the
product.
W Death, serious injury or damage to property
may occur if the above is not followed
exactly.
Assembly Instructions
DO NOT RETURN TO PLACE OF PURCHASE.
For assistance, call 1.800.762.1142 toll-free. Please
have your Owner's Manual and model number
available for reference.
Note: The model number can be found on the back or
side of the camp stove.
Assembly Tips:
1. Select an area where you will assemble this
product. To protect components, choose a smooth
surface that's free of cracks or openings.
2. Spread out all parts.
3. Tighten all hardware connections by hand first.
Then, before completing each step, go back
and fully tighten all hardware. Be careful not to
over-tighten. That could damage surfaces or strip
threads.
4. For best results, complete each step in the order
presented.
To complete assembly you will need:
• (1) Leak Detection Solution (instructions on how
to make solution are included in "Operating
Instructions" section).
• (1) 14.1 oz LP gas tank.
Typical assembly is approximately 5 minutes.
1. Lift Bottom Panel
2. Remove Cooking Grid
3. Remove Regulator
4. Close Bottom Panel
5. Unfold Legs
English – 3
6. Lift Lid
7. Unfold Wind Guard Side Panels
8. Insert Cooking Grid
9. Attach Regulator
10. When Not In Use
Operating Instructions
This camp stove is designed to operate with a one
pound 7-3/8" high disposable / 14.1 oz. propane gas
tank (DOT 39 Cylinder).
Do NOT ATTEMPT TO REFILL ANY ONE POUND
(14.1 oz.) PROPANE GAS TANKS!
Connecting LP Gas Tank
1. Make sure the control knobs are in the "OFF"
position (Figure 1).
2. Lubricate the threads of the regulator valve
with petroleum jelly. Insert the gas tank into the
regulator valve and hand-tighten firmly (Figure 2).
3. LP gas tank must be kept at a 45º angle
(Figure 4).
4. Test for leaks.
W To maximize use and prevent damage to
this camp stove and its components, you
must keep the LP gas tank a 45º angle. Not
doing so will void your warranty.
Disconnecting LP Gas Tank
1. Turn the control knob to the "OFF " position
(Figure 1).
2. Rotate LP gas tank counterclockwise until it is
detached (Figure 3).
3. Store the LP gas tank in a proper location, per
instructions on the LP gas tank.
Checking for Leaks
Burner Connection
1. Make sure the regulator is securely fastened to
the burner (Figure 7).
W WARNING: Failure to inspect this connection
or follow these instructions could cause a
fire or an explosion which can cause death,
serious bodily injury or damage to property.
2. If the burner/venturi tube does not rest flush to
the regulator, please contact 1.800.762.1142 for
assistance.
Regulator / 1lb. LP Gas Tank Connection
1. Make 2-3 oz. of leak detection solution by mixing
one part liquid dishwashing soap with three parts
water.
2. Make sure control knob is "OFF" (Figure 1).
3. Spoon several drops of solution, or use squirt
bottle, at the LP gas tank to regulator connection
(Figure 6 & 7).
4. Inspect the solution at the connections, looking
for bubbles.
a. If any bubbles appear, remove the LP gas tank
and reconnect, making sure the connection
is secure.
b. If you continue to see bubbles after several
attempts, remove the LP gas tank per
"Disconnecting LP Gas Tank" section, and
contact 1.800.762.1142 for assistance.
c. If no bubbles appear after one minute, turn
control knob to the "OFF" position, wipe away
solution and proceed.
First Use
1. Make sure all labels, packaging and protective
films have been removed from this camp stove.
2. Remove manufacturing oils before cooking on this
camp stove for the first time, by operating this
camp stove for at least 5 minutes on "ON." This
will "heat clean" the internal parts and dissipate
odors.
Lighting
W WARNING: Do NOT expose this camp stove
to flammable vapors or liquids during
lighting.
1. Make sure all labels, packaging and protective
films have been removed from this camp stove.
English – 4