Blueridge Digi-Touch DDN-SW1 Manual de instalação - Página 12

Procurar online ou descarregar pdf Manual de instalação para Interruptor Blueridge Digi-Touch DDN-SW1. Blueridge Digi-Touch DDN-SW1 13 páginas.

Imprimir página

B l u e

R i d g e

T e c h n o l o g i e s

Appendix B

LPPK Setup for Blue Ridge Technologies Digi-Touch Switches

Purpose:

Assign DDN-SW1 or DDN-SW2 switches to LPPK Groups in order to control the correct lighting circuits and report the Group status

back to the correct DDN-SW1 or DDN-SW2 button LEDs.

Steps:

1) Start LPPK. Go to main page as shown below. In the section, "Input # - Name", note the fixed input numbers along the left side fo

the page.

2) Go to the section "Assigned group", and to the column, "0-60". Assign a Group # to the input box. For each input, assign a Group

number. The Group number must equal the switch address. In other words, the Group # = the Input # = DDN dip switch # as shown

in the diagram. Note the fixed Input # on the left side of the page is in line with the Group # in the white input box on the right side of

the page.

3) Remember, the DDN dip switch # represents the upper button. Dip switch # + 1 represents the lower button. Include both numbers

in LPPK.

4) Set the Input Type to Momentary On/Off and Normally Open. Standard switches to the same panel are not required to follow this

"Input# = Group#" configuration.

Example: DDN-SW2 switches will command panel Groups 1-4. DDN-SW2 switches will also have an optional 2-hour timer and flash

enabled. The status of the panel groups are reported back to the correct DDN-SW2 LED. Standard switches control all other groups.

Dip Switch Numbers

are entered into LPPK

as Input Numbers and

Group Numbers.

Standard Input

Assignments

w w w. b r t i n t. c o m

Blue Ridge Technologies is a Trademark of Blue Ridge Technologies

Dip Switch Setting (under cover plate) is

assigned to each DDN-SW upper button.

Note

Add 1 for the lower button.

Multiple DDN switches can have the same dip switch setting.

Switches with the same see will control the same groups.

Note

Digi-Touch

Installation Guide

Dip Switch Number

is the Group Number

that will be used for

the status LEDs.

Optional Input

Flash and Timer

8 0 0 - 2 4 1 - 9 1 7 3

Note

page 12

Digi-Touch_IG.pdf

062310