Bluerock Tools CG-30 Manual operacional - Página 13

Procurar online ou descarregar pdf Manual operacional para Lanterna Bluerock Tools CG-30. Bluerock Tools CG-30 18 páginas. Track torch / burner machine

Imprimir página
C G - 3 0
T R A C K
T O R C H
Ø Select the drive direction using the toggle switch.
Ø Select the proper speed of the cut using the variable speed switch.
Ø Activate the machine start/stop lever to the start position to engage the machine directionally.
Ø When the cut is complete, stop the machine using the start/stop lever.
Ø Shut off the torch flame.

USING THE CIRCLE CUTTING ATTACHMENT

Ø Map out the circle on the surface of the steel.
Ø Drill a hole or use a punch to mark the center of the circle.
Ø Install the radius bar on the side main machine body.
o
o
o
o
Ø Install the radius bar spike on the end of the radius bar.
o
Ø Loosen the wing-nut on the wheel so the back wheels can swivel.
Ø Use the procedure above to start the machine and make the cut.
B U R N E R
M A C H I N E
If the radius is small, the bar should be placed on the same side of the torch.
If the radius is large, the bar and spike should be placed on the opposite side of the
torch.
Put into the fixed holes and adjust the position of the fixing bar accordingly.
Fasten the nuts to tighten the radius bar.
Tighten the spike.
10