Asko D5233XXL Manual de instruções de instalação - Página 7
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça Asko D5233XXL. Asko D5233XXL 16 páginas. Tall tank models
Também para Asko D5233XXL: Manual de Planeamento e Conceção (1 páginas)
Imprimir páginaCORNER INSTALLATION
If the dishwasher is installed in a corner, there must be a
minimum clearance of 2" (50 mm) from the side wall so
the door can open.
2" clearance
WATER SUPPLY
WARNING!!
Plumbing connections must comply with applicable
sanitary, safety and plumbing codes in your area.
The machine can be connected to either a hot or cold
water supply. If a cold water supply is used, the washing
times will be longer but the performance will not be
affected.
The dishwasher comes with a 6-foot PEX water supply
line that has a 3/8" NPT female connection.
After determining where the water supply line will enter
under the sink, drill a 1 5/8" to 2" (41mm to 50mm) access
EASYINSTALL CONNECTIONS
PEX tubing with 3/8" compression fitting
PEX tubing has a 95-year spec life. Fits
American dishwasher water supply
valves. Be sure to install the O-Ring
which is attached to the PEX tubing
in a plastic bag
Drain hose boot
Ready to be cut to desired
drain connection. Only
one clamp required.
Electrical cord
120 volts, 15 amp cord is supplied with
the dishwasher.
Warning!
Do not use an extension cord for this appliance.
INSTALLING THE TIP GUARDS
(OptIOnAL)
When it is not possible to fasten the dishwasher to the
cabinet, you should install a tip guard to prevent the
machine from tipping when the door is opened. The tip
guards can be attached either to the floor or the wall.
The tip guard should be mounted behind the machine,
18-1/2" (470 mm) from the front of the machine centered in
the width of the cutout opening. (Note: This measurement
could vary, depending on the thickness of the custom
panel, if any.)
Rear
NOTE:
We recommend that you install tip guards when it isn't
possible to fasten the dishwasher to the cabinet.
hole and run the line to the approximate inlet valve location
shown in the figure below. The water line inlet valve is on
the right rear of the machine.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily accessible
location, such as, beneath the sink.
It is important that the water supply line and the shut-off
valve have a sufficient flow volume. At last 3 gallons (12
liters) per minute must be able to pass through the line.
The water pressure should be 4.2-140 psi.
WARNING!
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water line
is connected to the dishwasher.
1. Water supply
2. Water supply valve to dishwasher (not supplied)
NOTE:
Be sure to run the PEX tubing through the hole to
sink compartment before moving the dishwasher into
position.
Customer Care Center
1-800-898-1879
www.askousa.com
Tip Guards
(P/N 8070851)
Page 7