Blueshape CGTR2P Manual de Instruções - Página 6

Procurar online ou descarregar pdf Manual de Instruções para Carregador de bateria Blueshape CGTR2P. Blueshape CGTR2P 16 páginas. Intelligent battery charger for 3-stud lithium ion batteries only

Imprimir página

If the battery is placed on charge, the AUX power will be

derived from both mains and battery if necessary.

Data connector for computer connectivity and monitoring of

BLUESHAPE batteries through BSCVMON free software,

directly downloadable from our website

Note: The special data cable is not included in the kit but is

available as a separate product.

This socket can also be used for firmware updates if necessary.

BLUESHAPE battery charging and performance features

The electronic circuitry provides a very accurate lithium ion charge

algorithm. Initially, the chargers will only apply a pre-charge current

of a few mA to batteries that are heavily discharged. Once the cells

inside the batteries reach a safe level, the full (maximum) charging

current is delivered at a maximum rate of 6A (but less than 0.5C)

until the batteries reach almost 90% state of charge (SOC). This

charging rate is only applied when the fan is set to ON.

If the fan is switched to OFF for silent operation, the charging

current is reduced to not exceed 3.5A (but less than 0.5C - see

table).

After the constant current (CC) phase is completed, a constant

voltage (CV) phase initiates with the current tapering slowly to

150mA until full cut-off.

*The output voltage of the auxiliary output is

dependent on the battery voltage. It can therefore

range between 12.5V up to 17V