d&b audiotechnik t-sub Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Subwoofer d&b audiotechnik t-sub. d&b audiotechnik t-sub 8 páginas.
Também para d&b audiotechnik t-sub: Manual (9 páginas)
Imprimir página
1
n.c.
2
3
4
5
1
2
3
4
Sense Drive
5
Fig. 2: Connector wiring
T-SUB Manual
Connections
The T-SUB cabinet is fitted with a pair of EP5 connectors. All five pins of
both connectors are wired in parallel. The T-SUB uses the pin
assignments 3/4 and 5. Pin 5 is used for SenseDrive (only available
when using a D12 amplifier and 5-wire cabling). Pins 1/2 are
designated to d&b full range systems. Using the male connector as the
input, the female connector allows for direct connection to additional
loudspeakers.
The T-SUB can be supplied with NL4 output connectors as an option.
The D12 SenseDrive function is not available when using NL4
connectors.
Pin equivalents of EP5 and NL4 connectors are listed in the table below.
EP5
1
NL4
1+
Operation
NOTICE!
Only operate d&b loudspeakers with a correctly configured d&b
amplifier, otherwise there is a risk of damaging the loudspeaker
components.
Applicable d&b amplifiers:
D80/D20/D12/D6/10D/30D.
Application
Setup
T-SUB
T-SUB
Within applicable d&b amplifiers, the controller setup is available
in Dual Channel or Mix TOP/SUB mode.
Controller settings
100 Hz circuit
If the 100 Hz circuit is selected, the upper operating frequency of the
system is reduced from 140 Hz to 100 Hz.
(1.1 en)
2
3
4
1–
2+
2–
Cabinets per channel
2
Page 5 of 8
5
n.a.