d&b audiotechnik R70 Manual - Página 8

Procurar online ou descarregar pdf Manual para Equipamento de gravação d&b audiotechnik R70. d&b audiotechnik R70 20 páginas. Ethernet to can interface
Também para d&b audiotechnik R70: Manual rápido (2 páginas)

Imprimir página
R70 Hardware
[2]
Page 8 of 20

2.1.3. CAN-Bus connectors [2]

Two RJ 45 connectors are located on the left hand side panel of the
device. Both connectors are wired in parallel to allow different wiring
setups of the CAN-Bus
Shielded cables and shielded RJ 45 connectors must be used
NOTICE:
to connect the devices of the d&b Remote network (CAN-Bus). The
cable shielding must be connected to both sides of the RJ 45 connector
as the "CAN Ground" is routed via the cable shielding.
RJ 45 [2]
Pin
1
2
3
4
5
6
1..45..8
7
8
Shell
Table 2: RJ 45 (CAN-Bus) pin assignment
d&b audiotechnik GmbH
Signal
Remark
-
-
-
CAN high bus line (active high)
CAN_H
CAN low bus line (active low)
CAN_L
CAN ground
GND
R70 Ethernet to CAN interface, Manual