Bluesound A860 Manual do Proprietário - Página 7
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Bluesound A860. Bluesound A860 11 páginas.
Imprimir página10 INPUT/OUTPUT (ZONE 1 - 4)
• These INPUT/OUTPUT terminals are dedicated to their respective
ZONE SPEAKERS.
• Always turn OFF the A860 and other components in the system
before connecting or disconnecting anything to the INPUT/
OUTPUT terminals.
• Ensure that the supplied INPUT/OUTPUT terminal block's "+, -,
GND" are wired accurately to corresponding OUTPUT terminals
of compatible external devices such as preamplifiers, processors
or other applicable devices. Install the wired up INPUT/OUTPUT
terminal blocks to corresponding A860's ZONE INPUT terminals.
• Ensure that the supplied INPUT/OUTPUT terminal block's "+, -,
GND" are wired accurately to corresponding INPUT terminals of
compatible external devices such as amplifiers, receivers or other
applicable devices. Install the wired up INPUT/OUTPUT terminal
blocks to corresponding A860's ZONE OUTPUT terminals.
• The ZONE OUTPUT terminal is a line level "loop through"
output. The same level of input signal at a particular ZONE
INPUT terminal is available at the corresponding ZONE OUTPUT
terminal thereby allowing the same signal to be shared or passed
on to another amplifier.
11 TRIGGER - OFF/ON/AUTO
• The TRIGGER switch has three settings - OFF, ON or AUTO.
• At OFF setting, +12V TRIGGER OUT will output 12V when A860
is at operating mode and 0V when it is at standby mode or
powered OFF.
• At ON setting and with the +12V TRIGGER IN of the A860
connected to compatible external equipment that is equipped with
a +12V TRIGGER output, the A860 can be switched remotely
from standby mode to operating mode and vice-versa.
• At AUTO setting, the A860 will instantaneously turn to
operating mode from standby mode if it senses any input signal
(approximately above 20mV RMS input) applied through any of
the GLOBAL or ZONE INPUT sockets.
12 +12V TRIGGER IN/OUT
• Use the supplied 12V TRIGGER terminal block connector to
connect +12V TRIGGER IN terminal to compatible external +12V
Trigger source and +12V TRIGGER OUT terminal to compatible
external equipment that is equipped with a +12V TRIGGER input.
Install the wired up +12V TRIGGER terminal block to A860's
+12V TRIGGER IN/OUT rear panel terminal.
• The +12V TRIGGER IN allows the A860 to be remotely switched
from standby mode to operating mode and vice-versa by
ancillary equipment such as a preamplifier, AV processor, etc. The
controlling device must be equipped with a +12V trigger output to
use this feature.
• The +12V TRIGGER OUT is used for controlling external
equipment that is equipped with a +12V trigger input. With
TRIGGER - OFF/ON/AUTO set to OFF, this output will be 12V
when the A860 is at operating mode and 0V when it is at
standby mode or powered OFF.
• Refer also to the item about "TRIGGER - OFF/ON/AUTO".
IDENTIFICATION OF CONTROLS
7