Ambient Recording Clockit Master Slate ACD101 Manual - Página 4

Procurar online ou descarregar pdf Manual para Acessórios de áudio e vídeo Ambient Recording Clockit Master Slate ACD101. Ambient Recording Clockit Master Slate ACD101 5 páginas.

Imprimir página

ENTER user only and retain running time by holding down both buttons 3

seconds or move cursor right to enter time domain. Set time in a similar manner

to user and enter time by pressing the two buttons simultaneously. Displayed

time is entered and also selected user bits. To change time while retaining user

move cursor through user domain to reach time or move cursor left into time

domain. Don't change user on the way!

The setting mode can be terminated at any time by closing the clapper. the

clapper will show old time and user.

Setting with external timecode

Plug in the external timecode through the lemo socket. The generator LED will go

red then green. Withdraw the external timecode on the green Phase. After 5

seconds the generator will be jamsynced again.The LED will go red then green

again. After the external timecode has been removed the green led must continue

blinking. The generator will change to the framerate entered.

Setting with ASCII.

Connect Ambient controller or Aaton Origen C to clapper with ASCII blue

Cable.Initiate ASCII or tune process.The led will change to green. Remove cable.

1.6 Reader

Clapper functions remain the same

Set DIP switch to reader and framerate

Connect external timecode.

Display will show timecode up to 1.5X speed

1.7 Clapper function

Open clapper,Time displays. Shut clapper, user bits display. After 5 seconds

display shuts off.The display can be reversed to show userbits then time.

Press button, time is displayed. release button, time changes immediately to user

bits and a buzzer sounds from the moment of changeover for 300 mS. The display

shuts off after 5 seconds. The display can be reversed,

1.8 Permanent display

Open clapper. Time shows

Shut Clapper.Set dip switch to permanent Display.Time shows

1.9 External Slate extension.

Move battery slider to expose slot

Slide in slate extension. Lock with battery slider.

use board marker and dry wipe clean.

1. 10 Changing batteries

Use only alkaline batteries duracell or equivalent

the batteries can be change without losing time the internal battery backup runs

for 5 minutes. this backup is also used to cover momentary loss of battery contact

should the clapper be dropped shaken or the sliding lid inadvertently opened.