ambiq micro Apollo3 Blue Plus Manual de início rápido - Página 9

Procurar online ou descarregar pdf Manual de início rápido para Placa-mãe ambiq micro Apollo3 Blue Plus. ambiq micro Apollo3 Blue Plus 15 páginas.

Apollo3 Blue Plus EVB Quick Start Guide

Ultra-Low Power Apollo MCU Family

Figure 4. Apollo3 Blue Plus EVB's DEBUG OUT Header (J2)

To utilize this functionality, use a 10-pin low-pitch standard debug connector to connect the "DEBUG OUT"

header (J2) on the EVB to the debug header on the target board. The EVB will automatically detect when

the "DEBUG OUT" header is connected to another target board and reconfigure the integrated J-Link to

connect to this external board rather than the on-board Apollo3 Blue Plus.

Note: A voltage on pin 1 of the J2 header is required for the above mentioned automatic switch to occur.

Also, if the target VDD doesn't match the on-board voltage (either 3.3V or 1.8V), and to avoid possible

voltage level conflicts on the debug I/O port, VDDIO of the J-Link processor may need to be changed to the

target voltage by cutting SB5 and shorting SB6.

An LED (D3) is on the board to indicate the presence of VDD_EXT_DBG on pin1 of the J2 header. When

D3 is ON, the debugger is debugging external target board. When D3 is OFF, the debugger is debugging

the on-board Apollo3 Blue Plus MCU.



Figure 5. Apollo3 Blue Plus EVB's DEBUG OUT LED (D3)

QS_A3P_1p1

Page 9

2020 Ambiq Micro, Inc.