AMCI DC60 Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Медиаконвертер AMCI DC60. AMCI DC60 20 страниц. Multi-turn analog output duracoder
Печатать страницуAnalog DC60 User Manual
Mating Connector and Cordsets
The following mating connector is available from AMCI. Note that any commercially available M12 connec-
tors with the proper coding and contacts can be used.
AMCI #
MS-37
AMCI offers the following cordset for use with the DC60.
AMCI #
CNFL-5M
Status LED
Each DC60 has a Status LED on its rear cover. Figure 4 shows an end connect
unit. The LED is in the same location on side connect units. This LED indi-
cates whether or not output is driving a load (cable break detection) and gives
a rough indication of the value of the analog output when it is driving a load.
Table 3 shows the different blink patterns.
Blink Pattern
Alternating
Red/Green
Blinking Green
50% duty cycle
Blinking Green
10 to 90% duty cycle
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
Description
Female, A-coded, 8 contacts. Screw terminal connections.
6 to 8 mm dia. cable. Maximum 20 AWG wire dia.
Straight, IP67 rated when properly installed.
Table 1 Available Mating Connectors
Description
Molded cordset. 5 meters in length.
Straight M12 8 pin A-coded to flying leads
IP67 rated when properly installed.
Table 2 Available Cordsets
Description
The DC60 is not driving a load. Most com-
mon causes are a mis-wiring or brake in the
cable.
The DC is driving a load and the shaft is
rotating. The LED is on for 1 second, off
for 1 second.
When the analog output is at its minimum,
the duty cycle will be 10%. When the ana-
log output is at its maximum, the duty cycle
will be 90%. The period is two seconds, so
the minimum on time is 0.2 seconds.
Table 3 Status LED Blink Patterns
DC60 S
PECIFICATIONS
Rear View
Status LED
Figure 4 Status LED Location
9