FLO-DYNAMICS BrakeMate Jr Инструкции по быстрому запуску
Просмотреть онлайн или скачать pdf Инструкции по быстрому запуску для Сервисное оборудование FLO-DYNAMICS BrakeMate Jr. FLO-DYNAMICS BrakeMate Jr 2 страницы. Brake flush machine
Также для FLO-DYNAMICS BrakeMate Jr: Руководство (17 страниц)
Печатать страницу
R
Flo-Dynamics, Inc. • 2600 Jeanwood Drive • Elkhart, IN 46514 • 800-303-5874 • www.flodynamics.com
BRAKE FLUSH MACHINE
CONNECTION
Remove master cylinder cap. Find correct master cylinder adapter
from adapter kit and attach to master cylinder reservoir. Connect
yellow pressure hose to master cylinder adapter.
Attach the tube from the used fluid bottle to one of the vehicle's
bleeder screws. You may need to verify that the bleeder screw can
be opened before attaching the tube. The bottle may be mounted
to the caliper using the attached magnet.
Connect the battery cables.
OPERATION
Turn the machine on and use the pressure regulator to
increase the pressure to the desired amount. A typical brake
service should not require more than 12psi (see manufacturer's
recommendation).
Slowly open the ball valve on the yellow pressure hose while
checking for leaks around the master cylinder adapter.
Open the bleeder screw about 1/4 turn until fluid begins to flow
into the bottle.
If the new fluid tank level becomes too low, the light on front
of machine will illuminate and the machine will beep. To restart
the machine, simply add more fluid to the new fluid tank.
When finished, close the bleeder screw and remove tube from
fitting. Repeat process on the remaining three wheels.
DISCONNECTION
After brake flush is complete, turn the machine off and disconnect
the battery cables.
Close ball valve on yellow pressure hose, press and hold Pressure
Release Button to relieve pressure, and then disconnect hose from
master cylinder adapter. Remove the adapter and replace the
master cylinder cap.
QUICK START
INSTRUCTIONS
945013