Amcor AM-90 IB Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Очиститель воздуха Amcor AM-90 IB. Amcor AM-90 IB 6 страниц. Amcor air purifier owner's manual am-90 ib

Печатать страницу

Features and Benefits

• High performance air purifier/ionizer for large areas and concentrated use.

• The Washable PET Filter (Polyester Filter Medium) is able to be washed at least 8 times.

This is the equivalent of using a filter for three years, in normal environmental conditions.

• Electronic Control

• Big clear LCD display

• Three Speeds

• A Clock that shows the correct time as long as the unit is turned on.

• A Timer that allows the user to operate the unit continuously, or up to 8 hours at increments

of 1 hour.

• Quiet Operation: Noise level is less than 50 dB.

Placement of the AM-90 Air Purifier

Attention: Before deciding on a location for your AM-90 Air Purifier, carefully

read all the operating instructions as well as all the following information.

1. Do not place this unit in close proximity to electronic devices that are

sensitive to electrical fields.

2. Do not place this unit on metal shelving or on any electrical device.

The AM-90 Air Purifier may be placed on the floor, nightstand, table or desk

with its air outlet facing the user in order to allow proper air flow.

3. IN ORDER TO PREVENT DIRT BUILD-UP, IT IS RECOMMENDED TO KEEP THE UNIT AT

LEAST 1.5 FT. (45 CM) FROM ANY NON-WASHABLE SURFACE.

The principle upon which the ionizer works is ionization. The process of ionizing accelerates the

fallout of pollutants from the air. These pollutants may adhere to surrounding surfaces, causing a dark

smudge. Therefore placement of the unit away from ALL NON-WASHABLE SURFACES is a

must!

How the Air Purifier Works

Control Panel and Operation

POWER

SPEED

Turning on the AM-90

A. When the unit is plugged into the power supply or when one of the buttons is pressed,

the unit will make a beep sound.

B. If the AM-90 is off (the LCD screen is blank) and the POWER button (1) is pressed, it will go into

the stand-by mode where only the time will be displayed. The blue LCD backlight will turn on when

one of the control buttons is pressed.

C. If the unit is operating or in stand-by mode and the POWER button (1) is pressed,

the unit will go off.

Setting the Time:

A. The first time the AM-90 is switched on (after being plugged into the outlet and pressing the

POWER button), the time will be displayed with all zeros.

B. Press the TIMER button (4). Hold in for a few seconds. The hour digits will flash.

C. Hold down the IONIZER button (3) and the hour digits will scroll down.

Press the IONIZER button (3) and the hours will count down in single steps.

Stop when you have the correct hour setting. In a few seconds the minutes digits will flash.

D. Hold down the IONIZER button (3) and the minutes digits will scroll down.

Press the IONIZER button (3) and the minutes will count in single steps. Stop when you have the

correct minutes setting. In a few seconds the time digits will stop flashing and time will be set.

E. The SPEED button (2) works like the IONIZER button (3), but the digits count up.

F. As long as the unit is plugged in, the unit will keep track of the time (even in the off mode,

when the LCD screen is blank).

G. Note: The time can only be set, when the unit is in the stand-by mode.

IONIZER

TIMER