Amdi TECH-SCAN32 PLUS Инструктивный лист - Страница 6

Просмотреть онлайн или скачать pdf Инструктивный лист для Сканер Amdi TECH-SCAN32 PLUS. Amdi TECH-SCAN32 PLUS 7 страниц.

CLEARING THE PROGRAMMED POSITION:

Place the unit face down on a flat surface so that the bottom is seen.

Remove the screw holding the door for the keypad closed.

Remove the door by pressing the clip forward and unlocking the door.

Turn the power On by turning the Volume control clockwise.

Plug in the remote device to be controlled either into an AC outlet or into a light socket if you are controlling a

remote light bulb.

Slide the PROGRAM switch RF SW1 up to the ON position.

Dial in the 9 digit Programming ID code (see diagram REMOTE AC OUTLET & REMOTE LIGHT BULB) from

the device that you are going to control using the keypad (the Programming ID code is labeled on each device). The

numbering sequence for the keypad (see diagram – BOTTOM VIEW) is from the top left A=1, B=2, C=3, D=4, E=5,

(top right), A - =6, B - =7, C - =8, D - =9 & E - =0.

Press the OK button, the Programming LED on the Remote AC receiver will turn ON.

Press and hold the CX button down (next to the OK button), The LED on the remote AC receiver will flash 2 times or

the Remote Light Bulb will flash 2 times.

10.

Press the OK button again, the programmed number is cleared from that location.

PROGRAMMING THE INFRARED CONTROL LOCATIONS:

Place the unit on a flat stable surface.

Set the level Select switch to Level 2.

Turn the power On by turning the Volume control clockwise.

Set Programming Switch IR1 SW2 (on the Programming Keypad) to the ON position (see diagram below).

Point the transmitting LED of your remote that you what to copy directly at the infrared receiver on the Programming

Keypad (see diagram below) and place it about ¼" to 1" away.

Press and hold down the button on your remote that you what to copy for 10 seconds then release, the programming

LED on the Programming Keypad should turn Red and stay ON.

Press one of the Programming buttons 1,2,3,4,6,7,8,9 (see diagram below) Buttons 1thru 4 & 6 thru 9 relate to the top

row of 32 position membrane. 1 relates to the top left (J1 see diagram Grid View above) and the remaining button

follow along in numbered order to the right where 9 is the right most position of the top row or J8.

Press and hold the same button on your remote again until the Programming LED on the Programming Keypad

flashes.

Press the same Programming button position again that you pressed in step 6, the programming LED will flash twice.

10. Press the Programming button position again to finalize the programming of that button.

11. Set the Programming Switch to the SW2 OFF position.

12.

Repeat steps 4 through 11 to program the next Infrared command.