ACR STOVES PR-1200e Руководство по эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Крытый камин ACR STOVES PR-1200e. ACR STOVES PR-1200e 17 страниц. Electric fireplace insert range
Печатать страницу
• The appliance can be operated manually
using the controls situated on the top right
hand side of the insert.
• On/off power switch – this is used to turn
the mains supply to the appliance on or off.
When the switch is in the ON position, the
orange stand by indicator light will show on
the top right corner of the screen. This switch
needs to be in the ON position to operate
manually or via the remote control / app.
• STAND BY - Used to switch the appliance to
Standby Mode
Please note batteries are not included. 2 x AAA batteries are required.
Controls
Manual Controls
• FLAME - Pressing this button will allow you
to cycle through the 4 flame settings
• HEATER - Press this once to select low heat
(the indicator light will glow orange), twice to
select the high heat (the indicator light will
glow red), three times to switch the heater off.
The heater will blow cold air for a number of
seconds once switched off before coming to
a stop. Please note that the heater will only
operate when the room temperature is below
the temperature indicated on the remote
control handset. This can be altered via the
handset or via the app.
• MODE - This allows the appliance to go
through a pre-programmed sequence of
effects. To use this, press and hold the MODE
button until it beeps (approx 4 seconds) and
the selection of pre-programmed sequences
will commence.
Remote Control
11
• Remove the battery/control panel
cover by sliding completely down
and insert 2 x AAA batteries
ensuring these are inserted
correctly. Slide the cover back up to
the original position to refit. Old
batteries should be disposed of
responsibly at a local recycling
location.
• Ensure that the ON/OFF power
switch on the unit is in the ON
position.
• Aim the remote control handset
directly towards the fire and press
the function button required.
• Sliding the door down on the
remote control will reveal more
functions. Otherwise using the
basic remote control buttons will
operate the fire in the same way as
the manual control buttons.