CoachComm X2 Как сделать

Просмотреть онлайн или скачать pdf Как сделать для Конференц-система CoachComm X2. CoachComm X2 3 страницы. How to change antenna diversity settings

How to Change Antenna Diversity Settings

The following document contains new antenna setup and operation procedures implemented with X-System firmware version 1.1.

Terminology Clarification: In other X2 package documentation, the term "Antenna" refers to the combination of the Radio Transceiver

device and its attached antenna. Within this document, "Radio Transceiver" (or "RT") refers to the device, and "antenna" refers to

one of the RT's detachable omni-directional whip antennas.

With the release of firmware version 1.1, CoachComm adjusted X-System's antenna diversity protocol for Radio Packs, which

will improve performance. In conjunction with the Radio Pack antenna diversity adjustments, we enhanced Radio Transceiver

performance by enabling single antenna operation.

For best performance, after

RT, which requires a change to each RT's device settings within the system's configuration file (CCF). Follow the procedures below to

update your system. For assistance with your X-System, please contact CoachComm's customer support at 1.800.749.2761.

Make the following changes to your CCF within X-Ware after you update your system to version 1.1. You only need to update the

CCF with this change once.

1. Connect all components of your system, including connecting a Cat 5 cable from your PC to the LAN port on the rear of

the X-System CU (in the Press Box Rack Unit.) See

CU rear and the location of the LAN port.

NOTE:

The PC you use for this process needs to have X-Ware version 1.1 installed on it. See the X-Ware 1.1

Update Device Firmware

2. Power on your system, select Home or Away on the CU, and allow your CCF to load.

3. Update your PC's IP Address and LAN Settings using the following instructions. (See

Manual

for a screen shot of this process.)

Right-click your PC's connection icon and select Open Network and Sharing Center. (Or access the same window

from your PC's Control Panel.)

Click Local Area Connection near the upper right of the window. The Local Area Connection Status window will

display.

Click Properties . A Local Area Connection Properties window will display.

Double-click the Internal Protocol Version 4 (TCP/IPv4) option from the list of connection properties. A TCP/IPv4

Properties window will display.

Click the radio button beside Use the following IP Address , then type 192.168.10.99 in the field. Click OK.

6. Open X-Ware and tap the gears icon in the upper right corner to open X-Ware's Advanced Settings window.

C o a c h C o m m

updating your system to version

document for more information about updating your system.

Process continues on next page.

X2 Package - Antenna Diversity Settings

1.1, RTs should be set up and operated with a single whip antenna per

page 14 of the of the X-System Operating Manual

for a diagram of the

page 33 of the X-System Operating

F i r m w a r e R e l e a s e N o t e s

How to