Cannot Print Properly from the Digital Camera
The following messages may be displayed on the cameras or camcorders when images are printed
directly. Take the appropriate action to correct the error.
This section describes errors that can occur when you connect a Canon "Bubble Jet Direct" compatible
digital camera to the printer.
• Images can be printed directly from a "PictBridge" or Canon "Bubble Jet Direct" compatible
digital cameras and digital video camcorders connected to this printer.
• If the connected digital camera or digital video camcorder is not supported by this printer, the
Power lamp on the printer will flash nine times. If this happens, disconnect the connection cable
and press the Resume button.
• If the operation time or data transmission time is too long, a communication time error may occur
and no more images can be printed. If this error occurs, disconnect the camera connection cable,
press the Resume button and then connect the cable once again.
The digital camera should be turned on automatically. If not, turn it on manually.
• A low ink warning is not displayed on the digital camera.
• For more details, also refer to the user's manual for the digital camera or digital video camcorder.
Error message on
camera
Printer in use
Printer warming up
No Paper
Paper Jam
Printer cover open
No print head
Waste tank full
Printer error
Images are printed from the computer.
Wait until printing ends.
Wait until warm-up ends.
Load the paper in the printer and press the Resume button on the
printer.
Remove the jammed paper, load new media, and press the Resume
button.
Close the front cover.
The Power lamp on the printer flashes five times.
No print head is installed. Install a print head according to the Quick
Start Guide.
When there is a print head installed, the print head is defective.
Contact a Canon service representative.
The waste ink tank is nearly full.
Press the Resume button on the printer to recover from the error.
Contact a Canon service representative as soon as possible.
An error requiring servicing has occurred. (The Power lamp on the
printer flashes alternately orange and green.)
Turn off the printer, unplug the power cord from the power supply, plug
the power cord back in, and then turn on the printer. If the same error
occurs, contact a Canon service representative.
Try This
45
Печатать страницу