Aktobis WDH-H3 Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Очиститель воздуха Aktobis WDH-H3. Aktobis WDH-H3 12 страниц.

8.) Filter change / filter change indicator

The unit is equipped with a filter change indicator. Depending on the duration of use and the degree of soiling, this

may be signalled to you by the indicator panel flashing ! This is the time when the pre-filter should be cleaned

and/or the fine filters replaced.

Notes:

 Under normal conditions, the fine filters last for approx. 4,300 operating hours or up to 18 months with an

operation of approx. 8 hours per day ! In more polluted rooms, e.g. smokers' households, the filters may have

to be replaced after approx. 6 months (at the latest when the HEPA filter is dark brown, it should be replaced) !

 Disconnect the mains plug before cleaning/replacing the filters. For best filtration results, we strongly

recommend that you use only original filters from the manufacturer.

 Never wash the fine filters. (Only the pre-filter and the ESP filter can be cleaned).

To change the filter, follow the instructions and diagrams as described earlier in the operating instructions under

point 3.).

After the pre-filter has been cleaned and/or the fine filters have been replaced, it is necessary to reset the filter

change indicator. To do this, switch the air purifier on again and now press the On/Off button

approx. 3 seconds! The successful reset is signalled by a short acknowledgement tone. In addition, the flashing of

the display field will stop again.

Cleaning the ESP filter block:

The ESP filter block made of stainless steel can be cleaned as follows.

 Carefully pull the ESP filter block out of the drawer like a honeycomb (touch

the top and bottom).

 First remove the coarse dust and dirt with a hoover.

 Then brush the fins of the ESP filter block with a soft brush.

 Again, remove any loose dust and dirt with a hoover. Also remove any dust

residue from the drawer itself.

 Now rinse the ESP filter block in a sink with the help of washing-up liquid and

a soft brush (see illustration opposite).

 Allow the ESP filter block to dry completely.

 Finally, push the ESP filter block back into its drawer and close the filter

compartment door properly.

9.) Cleaning & Storage

Please always disconnect the mains plug first and allow the air purifier to drain completely before carrying out any

cleaning activities on your unit !

9.1 Cleaning:

 Use a soft and damp cloth to clean the outside of the unit.

 Only use mild cleaning agents to clean your air purifier.

 Please ensure that water does not get into the interior of the unit or the electrical display panel (display) at any

time !

9.2 Storage:

 We recommend covering the unit for storage or ideally packing it in its original box.

 Store the unit in a dry and sufficiently ventilated place/space.

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de

permanentlyfor