Aktobis AG WDH-BGP02 Краткое руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Нагреватель Aktobis AG WDH-BGP02. Aktobis AG WDH-BGP02 8 страниц. 2 kw

1.3 Now set the desired temperature switch-off point (0 ~ 45°C) with the stepless

thermostat control dial (right-hand knob). This is best done as follows: Turn the

thermostat knob to the highest temperature (MAX.) and let the heater run until your

desired temperature value is reached. Now turn (adjust) the control downwards

towards the minimum until the heating function switches off automatically. Now leave

the control dial (thermostat) in this position and whenever it gets colder in the room,

the unit automatically starts heating and when the adjusted temperature is reached

again, the unit automatically switches off again!

Note: A short fan run-on may occur at high temperatures.

When the internal thermostat or the heating coil have cooled down sufficiently,

the fan also switches off immediately.

Switch off

To switch off the appliance, turn the stepless thermostat control knob (right-hand knob) to

minimum (min.) and allow the appliance to run in fan mode for about 5 minutes to cool

down. Then also turn the operating strength adjustment knob to "0" to switch off the unit

completely.

Cleaning & Storage

Always unplug the heater from the mains and allow it to cool down completely before

cleaning it !

3.1 Cleaning the housing:

Use a soft and damp cloth to clean the outside of the housing.

Only use mild cleaning agents to clean your heater.

Also, make sure that no aggressive cleaning agents are used, as these can damage

your appliance !

Please make sure that no water gets inside your heater at any time !

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de