American Sanders OBS-18DC Инструкции по безопасности оператора - Страница 5

Просмотреть онлайн или скачать pdf Инструкции по безопасности оператора для Сандер American Sanders OBS-18DC. American Sanders OBS-18DC 7 страниц.

Печатать страницу

American Sanders OBS-18DC Инструкции по безопасности оператора

Operating Instructions - Sanding

To operate the machine as a sander follow this

procedure:

1. Move machine to work location. Decide the best

approach to sanding the desired area. When

sanding the area, work so that you are moving

away from the power supply. This will help to

avoid entanglement with the power cord and

reduce the need to move the power cord as

frequently.

2. Install the abrasive. Use the same procedure

outlined in MACHINE SETUP for installing the

pad, to install the abrasive. Peel the film off the

back of the abrasive; center the abrasive over

the pad and press it against the pad. The

adhesive on the abrasive will hold it to the pad.

NOTE:

When using screen abrasive, set the

screen on the floor then move the

machine over the screen. Lower the

machine until the pad comes to rest on

the screen. Make sure the screen is

centered on the pad.

WARNING: Injury can occur if the machine is

connected to a power source while

installing the pad or abrasive.

Disconnect the machine before

installing the pad/abrasive.

3. Connect the machine to an appropriately fused

and grounded circuit.

4. Release the handle by pressing up on the locking

lever. Bring the handle to a comfortable position.

CAUTION: Do not lock the handle. Locking the

handle will prevent the machine from

resting evenly on the pad and

diminish the machine performance

and reliability.

5. Push the interlock button (1), and apply

pressure to the levers (2). To stop the machine,

release the levers (2). See figure 6.

CAUTION: To prevent damage to the flooring

and to reduce swirling, keep the

machine in motion while the motor

is running.

NOTE: For sanding cuts and sandpaper, see page 9.

Clarke

American Sanders

Operator's Manual (EN) - OBS-18/18DC

ENGLISH

Operating Instructions - Polishing

To operate the machine as a polisher follow this