Air & Allied Sales TOKU DIGGER TCD-20 Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Инструменты Air & Allied Sales TOKU DIGGER TCD-20. Air & Allied Sales TOKU DIGGER TCD-20 12 страниц.

Печатать страницу

Operator's instruction

Preparations before operation

Check following matters before operation.

Compressor

Capacity of the compressor is sufficient. Minimum requirement 11hp, 38CFM at 90psig (6.2bar)

Whether the drain has been removed.

Air Hose

Whether there is any damage to the air hose. Whether the size and length is correct.

Clean the interior of the air hose using compressed air.

When using two or more tools, all except leader hose should be 1" or large.

(See diagram above for piping and fittings.)

Inspection of the Air Breaker

Whether there is looseness in the screw thread areas.

Whether there is a crack or breakage in the main body.

Inspection of chisel

Whether the chisel is suitable for the shank of the Air Breaker.

Whether the chisel is suitable for the work.

Whether there is wear or cracks.

Whether the chisel is mounted correctly.

Wearing protective equipment

Whether the helmet, protective goggles, ear protection, gloves and working shoes are worn correctly.

Air Supply

Whether the air pressure is suitable. For best operation, supply tool with 90psig (6.2bar) of clean, dry air.

Higher pressure drastically reduces tool life and can void warranty. (600kPa for max)

Lubrication

To flush out GUM and DIRT - you should do the following two steps EACH DAY.

1. (Before the shift), pour a liberal quantity of gum solvent oil into the tool's air inlet.

2. Connect tool to air line and operate. Repeat this procedure before storing the tool.

Air line lubricator should be used in conjunction with the integral oiler.

Repeat this procedure before storing the tool.

Whether the oil is suitable for the Air Breaker. (turbine oil equivalent to ISO VG46)

Whether lubrication has been performed. (at least twice day)

The importance of adequate and continuous lubrication cannot be overemphasized.

A few minutes operation without oil may severely damage the valve parts, cylinder and piston.

[email protected]

Air & Allied Sales (Pacific) Pty Ltd