Air & Allied Sales UGC2005M Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Краскопульт Air & Allied Sales UGC2005M. Air & Allied Sales UGC2005M 10 страниц. Solvent based spray gun cleaner

Печатать страницу

Using the machine

Please Note: For best results spray guns should be cleaned as soon as
possible after use.
1
Any paint left in cup/pot should be emptied into a waste container or stored for future use.
Place paint cup/pot into machine over the top pair of square nozzle jets.
2
3
The air cap of the spray gun can either be loosened or removed completely and put into machine.
Fit the trigger clip to trigger of spray gun. See Diagram 3.
4
5
Put spray gun into machine. See Diagram 4.
a
If using a suction spray gun fit directly onto taper nozzle
If using a gravity or pressure spray gun use a nozzle extension.
b
6
Close lid.
7
UGC4005 and UGC5005 ONLY
Ensure mode valve control lever is in the automatic position (horizontal).
8
Turn timer knob clockwise (The machine will run automatically for approximately 4 minutes).
9
Upon completion open the lid and remove the spray guns from the machine. We advise that you
DO NOT store the spray guns in the machine.
WARNING:
• THE LID IS LOCKED DURING OPERATION FOR YOUR SAFETY
• THE LOCK MUST NOT BE REMOVED
• TO UNLOCK SWITCH OFF THE MACHINE
For UGC2005M Manual Wash and Clean Rinse begin this process at step two 'Open lid of
machine'.
MANUAL WASH
1
Turn Mode Control Valve on the front of machine to Manual Mode.
2
Open lid of machine.
3
Turn Manual Wash lever to the 'ON' Position and clean solvent will flow from central block and
washing brush
4
Proceed to wash spray gun manually.
CLEAN RINSE
1
Repeat steps one and two listed above
2
Turn Clean Rinse lever to the 'ON' Position and clean water will flow from central block.
3
Rinse the spray gun.
MANUAL WASH/ CLEAN RINSE
UGC4005, UGC5005 and UGC2005M.
Air & Allied Sales (Pacific) Pty Ltd
www.air-allied.com.au