Boca Flasher HPCCS Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для DJ оборудование Boca Flasher HPCCS. Boca Flasher HPCCS 6 страниц.
Печатать страницу1. INSTALL CLIPS INTO SUBSTRATE
1a
Determine layout of fixture or composition of fixtures
and locate appropriate clip location.
CLIP MUST BE A MINIMUM OF 4.5" FROM END-CAP TO
ALLOW CLEARANCE OF MOLDED CORDS.
Screw Information:
1. Screws not provided by Boca Flasher.
2. Boca Flasher recommends wide washer flat head Philips
#8 screw (not to exceed .418").
2. INSTALL FIXTURE INTO FIXED CLIPS
2a
Angle fixture into opening,
pushing clip wider as
you push.
3.
INSTALL FIXTURE INTO
3a
1b
3. Length of screw will vary depending on mounting surface.
4. For outdoor installations, installer should use a screw with weather
proof coating.
5. One foot fixtures only require one hinge bracket.
2b
Tab on side of clip should go in
notch at the top of the fixture.
HINGE
3b
PAGE 3 OF 6
Installation Instructions
1c
2c
Clip will securely snap
into place.
snap!
CLIPS
Installing Hinge Clips:
Hinge clips come installed on the fixture.
Therefore it is easy to determine where
to predrill the holes into the substrate
before doing so. Installing is only a
matter of drilling in the proper screws,
recommended.
HPCCS