Boca Systems Lemur-C Руководство по уборке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по уборке для Принтер Boca Systems Lemur-C. Boca Systems Lemur-C 5 страниц. Routine cleaning procedures
Печатать страницу
SENSORS (OPTO) CLEANING PROCEDURE
Clean Load Sensor
The load sensor (opto) is responsible for letting the printer know when media has been loaded into the printer.
1. Using inert dusting gas (canned air) or equivalent blow air over the opto eyes (see photo below).
Above is non-UPG paper path
2. Once the opto eye is cleaned, install the head by reversing the steps that was done
Procedure
Section.
Clean Cut/ Tear Sensor
There is one sensor (opto) mounted on a black plastic bracket beneath the paper guide (non-UPG path). The opto
controls ticket cut/tear position. Over a period of time there may be an accumulation of ticket dust on the opto eyes
themselves. This paper dust could cause erratic operation of the printer.
1. Using inert dusting gas (canned air) or equivalent blow air over the opto eye (see above diagram
In June 2021 the Universal Paper Guide (UPG) was introduced. Cut/ tear sensor will be located on the rail that has the
red dot on it.
Below is RADJW or ADJ
REV 07.08.22
Sensor Eye
Blow air in this area
(red dot on right rail)
Above is UPG paper path
Below is ADJW or ADJ2 path
Blow air in this area
Cut/ tear sensor holder
The Thermal Head Cleaning
).
(red dot on left rail)
5