BOCCHI LEVANZO 1635-504-0120 Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Сантехническая продукция BOCCHI LEVANZO 1635-504-0120. BOCCHI LEVANZO 1635-504-0120 20 страниц. Granite kitchen sinks

Печатать страницу

Drop-In Installation:

•

Locate the drop-in template in the sink box.

•

Cut along the appropriate line for your sink and installation. NOTE: Keep the inside of the template.

•

Place the template on the countertop and fix it in place using the painter's tape.

•

Trace the template with a pencil or marker to draw the mark where the sink will set. Remove the template.

•

Make certain there is adequate clearance for the faucet and backsplash. NOTE: the center faucet hole is

predrilled on the sink and will be in a fixed position once installed. 1635 models are not pre-drilled to

allow for reversible installation.

•

Add painter's tape around the outside edge of the marked line for protection of the countertop before

starting your cut.

•

Using the power drill, drill a starting hole for the saw in the area of the countertop to be cut out.

•

Carefully cut out the needed section using the appropriate type of saw for your countertops.

•

Determine the location of the faucet and add additional faucet holes in the sink if needed. The underside of

the sink has pre-scored holes to mark the locations where these should be drilled if necessary.

•

If drilling extra holes, carefully place the

sink upside down on a suitable and stable

surface. Use a 1 3/8 inch diamond hole

saw to drill in the pre-scored area(s) where

extra holes are needed. NOTE: No holes are

precut on the 1635 model to allow for the

drain board to be set on the right or left side

as desired; it will require a hole to be drilled

for a faucet.

•

Depending on your selected faucets, you may prefer to install the faucets and strainers now, before

placing the sink into the countertop. You may do so now following the instructions provided by the faucet

manufacturer.

•

Clean and dry the surface around the opening of sink.

•

Test to make sure that the sink fits in the opening.

•

Carefully, turn the sink upside down and install the mounting brackets provided for a drop-in installation.

Set the bracket so that the back wall of the bracket is towards the outside edge of the sink and the toes of

the bracket feet are faced towards the center of the sink. Tighten only the two small screws at this time.

Claw grip of the bracket should swing to the center,

or parallel to the sink edge, when dropping the sink

into position. Then swing away from the bowl's center,

towards the outside, to grip the underside of the counter,

during the final steps of installation.

back wall of bracket faced

towards the outside of the

sink

"toes" of the bracket

should face towards

the sink bowl

continued on next page