Domus FRESCO-52-LIGHT Руководство по установке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке для Вентилятор Domus FRESCO-52-LIGHT. Domus FRESCO-52-LIGHT 19 страниц.

Trobleshooting

Fan will not start

• Check 240Volts is available at terminal block.

• Check wire connections in the wall switch and terminal blocks, ensure all wires are making proper contact.

• Check isolation switch is "on".

Fan is not responding to the remote control

• Check for flat battery.

• Check handset programmed to receiver (refer to page 7).

• Occasionally there maybe a poor signal (location) received by the handpiece. This can be improved by ensuring the antenna is outside the

top canopy (see below Figure).

Fan is wobbling

•

• Check the ball joint slot is locked into the hanger bracket groove.

• Make sure blades are a matching set; the figures on matching sets of blades should be identical with the numbers varying within 3 grams

of each other.

• Check blade screws are tightened firmly.

• DO NOT use a power tool to tighten screws.

• Make sure bracket is tight against ceiling and the ceiling and the ceiling structure are not moving.

• DO NOT use countersunk screws to hold bracket against ceiling. Countersunk screws will make fan wobble (now or later) and allow the

bracket to move.

Fan is noisy

•

• Check all screws and parts are secured firmly. Ensure there are no loose parts moving inside the motor housing.

• Check ceiling bracket is secure. If ceiling canopy moves then the bracket or ceiling is moving and screws are either loose, not into structure

or of counter sunk type.

Troubleshooting Tips for Installers - Light

•

• Light will not turn on - Make sure lamp has not blown. Check all light wires in the terminal block in the canopy cover and the wall switch

have been connected correctly.

• Light flickers or flashes - Re-check wiring. Flickering may be caused by ripple control signals from the power grid.

• Light is not responding to remote control - Make sure lamp has not blown. Check all wires in the terminal block in the canopy cover and the

remote receiver have been connected correctly. Check hand piece battery.

Troubleshooting Tips for Installers - Remote Control

•

• Handset cross programming - One device (remote handpiece or wall controller) must be attached to the receiver at all times. In the event of

handpiece cross programming, please program the same handpiece/ wall controller twice to delete irrelevant/ unwanted device.

POWER OUTLETS OR FIXED WIRING MUST BE INSTALLED BY A LICENSED ELECTRICIAN

To protect your customer's WARRANTY please READ PAGE 2 of this booklet prior to the installation of this product.

Installation Manual

Date: November 18, 2022 10:32 am