DOMUS LINE 103377491 Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель DOMUS LINE 103377491. DOMUS LINE 103377491 17 страниц.

INSTALLATION MANUAL

TECHNICAL DATA

Input voltage:

12–24Vdc

Output voltage:

12-24Vdc

Maximum applicable load:

36W (with 12Vdc power supply)

72W (with 24Vdc power supply)

WARNINGS

Safety is guaranteed if these instructions are followed so they must be kept.

Installation may require involving qualified personnel. Before installing the

luminaire ensure that the environmental conditions are in compliance with

and suitable for product characteristics. Before any operation on the

luminaire, disconnect the mains voltage.

- DOTTI is a device for installation on the surface of panels made of wood,

plastic, granite etc. with the exception of metals such as steel, aluminium,

iron and similar.

- DOTTI can be installed with the cables in an axial or radial position in

relation to the mounting surface. For installations with the power cable in

the axial position, drill a ø ≥ 9mm hole in the mounting surface as shown in

the example in figure 1. For special requirements, it is nonetheless possible

to drill the power cable outlet hole in other positions as long as they do not

interfere with the integrity of the cable and/or connector installed on it.

- Fix the bracket (A) in the required position using the screws supplied (B).

- Connect DOTTI only to a safe power supply with 12Vdc or 24Vdc stabilised

voltage (sold separately) and with power at least 10% higher than the total

load. For the total load calculation check plate data printed on the product

label.

- For connection to a 24Vdc power supply (figure 2) insert connector (C) on

the DOTTI input cable (IN) to one of the free slots on the distributor (N) on

the Converter secondary cable; then connect connector (D) on the DOTTI

output cable (OUT) to connector (E) on the Micro-24 distributor cable (F).

- For connection to a 12Vdc power supply (figure 3) use the adapter cable (G)

and the Micro12 distributor (H) sold separately. Connect the DOTTI input

cable (IN) to the adapter cable (G) and then to one of the free slots on the

distributor (I) on the power supply secondary cable; then connect the

connector (L) on the DOTTI output cable (OUT) to connector (M) on the

Micro12 distributor cable (H)

- DOMUS Line guarantees the product only when powered with Converters

supplied by DOMUS Line.