American Standard Metering Faucets 6" Gooseneck Spout 1340.265 Инструкции по установке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по установке для Внутренняя отделка American Standard Metering Faucets 6" Gooseneck Spout 1340.265. American Standard Metering Faucets 6" Gooseneck Spout 1340.265 3 страницы. American standard center set faucets installation instructions

Печатать страницу

TEST INSTALLED FITTING

Turn on water supplies and check connections for leaks.

Remove AERATOR (1) with KEY (2) supplied.

Operate HOT and COLD HANDLES by pressing down on

HANDLES. Both Hot and Cold handles are set for approximately

8 second operating cycles.

Replace AERATOR (1).

WATER SUPPLIES

TO ADJUST CYCLE TIME

Remove HANDLE (1) by removing INDEX BUTTON (2)

and SET SCREW (3) with a 2.5mm hex wrench.

Pull off HANDLE (1).

To increase cycle time, turn the gray PLASTIC ADJUSTING

NUT (4) clockwise.

To decrease cycle time, turn the gray PLASTIC

ADJUSTING NUT (4) counter-clockwise.

Replace SET SCREW (3), INDEX BUTTON (2) and

HANDLE (1). Test faucet for proper operation and

cycle time.

2.5mm HEX WRENCH

TO DECREASE CYCLE TIME

ROTATE COUNTER-CLOCKWISE

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR

WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,

ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A

COARSE SURFACE.

PRESS HANDLE

DOWN TO

OPERATE

TO INCREASE CYCLE TIME

ROTATE CLOCKWISE

SERVICE

Remove HANDLE (1). Refer to Step 4 for handle removal.

Remove ACTUATOR ASSEMBLY (2).

Remove WASHER (3). Pull out VALVE ASSEMBLY (4) and

FILTER SCREEN (5).

Inspect that VALVE ASSEMBLY (4), FILTER SCREEN (5) and

VALVE SEAT (6) are clean and free from debris. VALVE

ASSEMBLY (3) and FILTER SCREEN (5) can be cleaned with

soap and water.

Replace FILTER SCREEN (5) and VALVE ASSEMBLY (4). Place

WASHER (3) on top of VALVE ASSEMBLY (4). Thread VALVE

ACTUATOR (2) onto faucet. Torque VALVE ACTUATOR (2)

to 12-15 ft. lbs (15-20 Nm).

Replace HANDLE (1).

REMOVE

CONVERT RIGID SPOUT TO SWIVEL SPOUT

(1340.255; 1340.265)

Unthread SPOUT NUT (1) and remove SPOUT (2)

Remove SPOUT CLIP (3) and O-RINGS (4).

Replace RUBBER RING (5) with separate

PLASTIC RING (6) supplied with faucet.

Replace SPOUT CLIP (3) and O-RINGS (4).

Reassemble SPOUT (2) TO BODY.

REMOVE

RUBBER RING

INSTALL

PLASTIC RING

REPLACE

968493