American Standard COLONY 2675 SERIES Руководство по эксплуатации и техническому обслуживанию - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Ванны American Standard COLONY 2675 SERIES. American Standard COLONY 2675 SERIES 10 страниц. Whirlpool/bathing pool, high gloss acrylic shown less all fittings
Также для American Standard COLONY 2675 SERIES: Инструкции по установке (4 страниц)
Печатать страницу
Operation:
SYSTEM II WHIRLPOOL with CHROMATHERAPY
BATHING:
• Fill bath with water at a comfortable bathing temperature - If your whirlpool is equipped with the
optional EZ-Heater, it will automatically maintain the water temperature.
• IMPORTANT: Do NOT fill the whirlpool more than 2/3 full before getting in, as it may overflow.
• IMPORTANT: Do NOT add bath oils or salts – this will damage the whirlpool pump.
• IMPORTANT: Water level must be at least one inch (25mm) above the highest jet before the whirlpool is started
Operating the system without water (dry running) for extended periods will cause pump damage and void the warranty.
OPERATING AIR MASSAGE and CHROMATHERAPY SYSTEM:
Function when in "Whirpool" mode
Function when in "Light" mode
AIR VOLUME CONTROL ADJUSTMENTS:
with the water. Rotate the air volume control counterclockwise for more turbulence, and clockwise for less.
FLOW JET VOLUME ADJUSTMENTS:
the nozzle counterclockwise for vigorous and clockwise for soft.
751733-100 Rev. H
Select "Whirlpool" mode
Pump On/Off
Select "Light" mode
Lights On/Off
WHIRLPOOL CONTROL:
Press this button to turn pump on and enter "Whirlpool" mode (button will light).
Once in "Whirlpool" mode, pressing button again will turn pump off.
LIGHTS CONTROL:
Press this button to turn lights on and enter "Light" mode (button will light).
Once in "Light" mode, pressing button again will turn lights off.
UP:
In "Whirlpool" mode - Press this button to increase to the next higher pump speed.
In "Light" mode - Press this button to change "up" to the next color.
DOWN:
In "Whirlpool" mode - Press this button to decrease to the next lower pump speed.
In "Light" mode - Press this button to change "down" to the previous color.
PULSE/CYCLE FUNCTION:
In "Whirlpool" mode –
• Press this button to start the pulse function (button will light).
• Pump speed will continuously vary between high and low.
• Press again to exit pulse function (button light will go out).
In "Light" mode –
• Press this button to start the cycle function (button will light).
• Light color will continuously cycle through the spectrum.
• Press again to exit cycle function (button light will go out).
• FAVORITE COLOR – If you stop the Cycle Function on a particular color,
the system will automatically return to this color the next time it is used.
Water flow-levels can be adjusted from vigorous to soft by rotating
Pump Speed
Increase
Change "Up" to
next color
Water turbulence is determined by the amount of air mixed
6
Pump Speed
Pump Pulse
Decrease
Function
Change "Down"
Color Cycle
to previous color
Function