D3FY SPORTS Conqu3st Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Оборудование для пейнтбола D3FY SPORTS Conqu3st. D3FY SPORTS Conqu3st 14 страниц.

Печатать страницу

MAINTAINING YOUR CONQU3ST PAINTBALL MARKER

Quick Clean and Disassemble

Make sure all paintballs are removed from the marker and that

the air source is detached before attempting any maintenance

and/or repairs. Push the Safety button to the "SAFE" position.

Cock back the bolt.

Note:

from rotating and moving forward. Pull upward on the Bolt

Cocking Pin to disconnect the Delrin Bolt (I-20) from the Striker.

Remove the Delrin Bolt by sliding it out the rear of the Receiver/

Body (X-10). Wipe off the Delrin Bolt using a clean cloth.

Use a squeegee or swab to clean the inside of the Receiver.

Insert the Delrin Bolt with the open face in first. Align the Bolt

Cocking Pin with the Striker hole and push down on the Pin

to lock it in place.

Important:

Bolt with the air passage hole located in the middle of the bolt

facing downwards. If the Delrin Bolt is not installed correctly,

PART # and Description

(X-10-B, X-10-OD) Receiver

(I-19) Delrin Bolt

(I-20) Bolt Cocking Pin

(I-25) Striker

(I-26) Striker Spring

(I-27) Striker Buffer

(I-31) Velocity/Spring Guide

(X-29) Striker Plug

This will help keep the Striker (I-25)

Make sure to install the Delrin

the paintball marker will not

function properly. With the

Bolt Cocking Pin properly

installed to the Striker, you

should now push the Safety

button to the "Fire" position.

The Delrin Bolt will slide

forward when you pull the

trigger.

Disassemble Rear Internals

1.With the Bolt in the un-cocked position, pull upward on the

Bolt Cocking Pin to disconnect the Delrin Bolt from the

Striker. Remove the Delrin Bolt by sliding it out the rear of the

Receiver.

2.Remove the Striker Plug (X-29) by unscrewing it counter-

clockwise. This will allow you to remove the Striker Spring

(I-26), Striker Buffer (I-27) and Striker from the rear of the

Tip:

Receiver.

Only remove the Striker Plug with the marker

in the un-cocked position. This will prevent the internals from

springing out when the Striker Spring is compressed.

The Striker Plug and Velocity/Spring Guide will come out as

one piece.

3.Remove the following items in order; Striker Spring, Striker

Buffer, and Striker

4.Clean any dirt, debris, or paint from the inside of the Receiver

Note: