Da-Lite ADVANTAGE ELECTROL Книга инструкций - Страница 9
Просмотреть онлайн или скачать pdf Книга инструкций для Проекционный экран Da-Lite ADVANTAGE ELECTROL. Da-Lite ADVANTAGE ELECTROL 12 страниц. Tensioned large
Также для Da-Lite ADVANTAGE ELECTROL: Книга инструкций (12 страниц), Руководство монтажника (2 страниц), Книга инструкций (4 страниц), Книга инструкций (12 страниц), Книга инструкций (16 страниц)
Печатать страницу
TROUBLESHOOTING
Visit www.da -lite.com/products/tutorials.php to find installation
and troubleshooting tutorials. You will also find a link to Live
Chat for interactive support.
Symptom
Screen will not operate
and motor does not hum.
Screen will not operate
and motor does not hum.
Power at junction box.
Screen does not stop
at correct position.
Noise.
NOTE: Screen will operate
with a low pitched hum.
Coasting.
Fabric hangs crooked.
Cause
Incorrect line voltage.
Blown fuse.
Tripped circuit breaker.
No power to operating switch
or junction.
Thermal overload tripped.
Broken wire in the "down" or "up"
position.
Defective motor, limit switch or
capacitor.
Capacitor burned out.
Limit switch out of adjustment.
Squeaking, rubber end plug rubbing on
motor.
Grinding. Foreign object in screen
rubbing on roller or fabric.
Gear noise.
Defective brake.
Screen not installed properly.
Fabric has backed up inside case.
Fabric is damaged.
You can contact us by email at [email protected] or by phone at
800.622.3737 or 574.267.8101 with any additional
troubleshooting questions.
Solution
Verify 115-125V (or 220-240V). If insufficient
voltage, rewire incoming electric line.
Replace fuse.
Reset circuit breaker.
Check above. Tighten all loose wire
connections. Correct any improper
connections.
Down Position
Check for power across black and white leads.
Up Position
Check for power across red and white leads.
Let motor cool down for 15 minutes. Try again.
Check for continuity. Cut off old splice and
reconnect.
Replace motor assembly. NOTE: Motor is a
sealed assembly.
Replace motor assembly.
See Screen Adjustment section.
Center roller in case.
Remove.
Replace motor assembly.
Replace motor assembly.
Check for level and plumb.
Adjust "down" limit switch slowly until roller is
exposed and wrinkle comes out, then readjust
for proper drop.
Replace fabric.
9