Da-Lite LARGE ADVANTAGE DELUXE ELECTROL Книга инструкций - Страница 4

Просмотреть онлайн или скачать pdf Книга инструкций для Проекционный экран Da-Lite LARGE ADVANTAGE DELUXE ELECTROL. Da-Lite LARGE ADVANTAGE DELUXE ELECTROL 13 страниц. Automatic electric projection screen
Также для Da-Lite LARGE ADVANTAGE DELUXE ELECTROL: Книга инструкций (8 страниц), Технические характеристики (2 страниц), Книга инструкций (10 страниц)

Печатать страницу

Da-Lite LARGE ADVANTAGE DELUXE ELECTROL Книга инструкций

Case Installation

The case has a self-trimming flange around the bottom. Ceiling tiles or drywall may be placed on top of this flange to provide a finished

appearance.

The case provides multiple attachment points for bolts, cables,

or threaded rod. Page 5 shows threaded rod installed. The

variable position-mounting bracket may be located anywhere

along the length of the case. It is recommended to keep the

brackets spaced evenly enough to distribute the weight of the

screen. One mounting bracket is required for every 4' of case

length.

Tighten bolts until trim flange is flush with ceiling.

NOTE: For proper operation, screen assembly must be level

after installation.

Remove 2 screws to open junction box. Install electrical

connections that apply to your unit. Make sure to review the

wiring diagram for proper hook up. Replace junction box

cover and secure with 2 screws.

NOTE: Motor Operator Projection Screen Models LADT,

LADDT, LAD and LADD must be installed in accordance with the

requirements of the Local Building Codes, the Canadian

Electrical Code (CEC), CAN/CSA C22.1 and the National Electric

Code (NEC), NFPA 70. An appropriate disconnect device shall be

provided as part of the building installation.

If your case was ordered in advance of the screen and roller

assembly, your installation is now complete. Continue to step

4 if your Large Advantage Deluxe Electrol was ordered as a

complete unit.

Carefully remove paper and tape from roller assembly

Caution! Do not use a knife or sharp object to cut tape;

you will damage the screen. Pull orange string.

ATTENTION! Ne coupez pas le ruban adhésif sur la toile

avec un couteau ou un outil tranchant. Tirez sur le cordon

orange.

Test installation by running screen up and down a few times.

Be prepared to stop screen should any objects obstruct the

movement of the screen. To prevent damage to the motor,

the standard duty cycle is 1 minute on and 3 minutes off.