Da-Lite Large Cosmopolitan Electrol Книга инструкций - Страница 2
Просмотреть онлайн или скачать pdf Книга инструкций для Проекционный экран Da-Lite Large Cosmopolitan Electrol. Da-Lite Large Cosmopolitan Electrol 12 страниц.
Также для Da-Lite Large Cosmopolitan Electrol: Книга инструкций (8 страниц)
Печатать страницу
Important Safety Instructions
When using your video equipment, basic safety precautions should always be followed, including the following:
1.
Read and understand all instructions before using.
2.
To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
Installation
Carefully unpack screen and remove outer wrapping from case.
Remove the black tape and rubber bands from the slat bar after the case has been installed.
The Large Cosmopolitan® Electrol® comes with brackets to allow for wall mount or ceiling mount installations. Procedures for each
method are as follows:
Wall Mount
1. The wall mount bracket should be fastened to wall studs or
some reinforcement within the wall. Concrete or brick walls
require special fasteners and anchors.
2. The wall bracket has holes spaced at 16" and 24" to align with
most wall studs.
3. The bracket must be level and plumb.
4. Keep in mind you will need at least 2-3/4" between the ceiling
and the top of the wall mount bracket to be able to position
the case on the bracket.
5. Mount the screen case on the wall bracket as shown in
figure 1. Be sure the case is fully seated on the bracket.
Tighten the stop screws against the wall bracket.
Ceiling Mount
1. Be sure the ceiling has adequate reinforcement to attach the
screen brackets.
2. Attach the ceiling brackets to the wall mount bracket using
the supplied 5/16" x 3/4" bolts, washers and nuts.
3. Position the ceiling bracket assembly on the ceiling and
attach with 5/16" bolts (not supplied). The bolts should be
long enough to pass through the drywall or ceiling tile and
penetrate at least 1-1/2" into the reinforcement in the ceiling.
4. Mount the screen on the wall bracket as shown in figure 2. Be
sure the case is fully seated on the bracket. Tighten the stop
screws against the wall bracket.
2
3.
The use of an accessory attachment not recommended by
the manufacturer may cause a risk of fire, electric shock, or
injury to persons.
2
"
Case Hook
Wall Mount
Bracket
Stop Screw
Case Hook
Ceiling Mount
Bracket
5/16 x 3/4" Bolt
Nut and Lock
Washer
Wall Mount
Bracket
Stop Screw
Viewing Surface
(Audience Side)
Figure 1
1 1/8"
Viewing Surface
(Audience Side)
Figure 2