Da-Lite Senior Electrol Книга инструкций - Страница 2
Просмотреть онлайн или скачать pdf Книга инструкций для Проекционный экран Da-Lite Senior Electrol. Da-Lite Senior Electrol 8 страниц.
Также для Da-Lite Senior Electrol: Книга инструкций (8 страниц), Книга инструкций (8 страниц)
Печатать страницу
Important Safety Instructions
When using your video equipment, basic safety precautions should always be followed, including the following:
1.
Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at
least equal to that of the appliance should be used. Cords rated
for less amperage than the appliance may overheat.
Pre-Installation
1.
Carefully unpack screen and remove outer wrapping
from case.
2. Remove instruction cover plate (Fig. 1). Do not remove metal
shipping brace (secures roller), wrapping paper, or tape strips
until screen is installed.
3. Make sure to recheck measurement of screen location
before installation.
Instruction Cover
Installation
Hangers (If required)
1.
Make sure one hanger is approximately 25" from end
of case (motor end).
2. Make sure second hanger is approximately 11 1⁄2" from
opposite end of case.
Wall or Ceiling Mount With Hangers
Wall Type Hangers with ceiling hanger adapters are
standard equipment. For wall type, use wall hanger only.
For ceiling type installation, use the wall type hanger and
ceiling adapters as shown in Fig. 3 on page 4.
2
Case
Figure 1
Wall Type Hanger
Picture
Surface
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric shock
when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by the
manufacturer may cause a risk of fire, electric shock, or injury to
persons.
Save These Instructions
NOTE: Screen is not centered in box. Screen surface
is set 185⁄8" from motor end.
Ironing Board
Senior Electrols 14' wide and over contain an ironing board to
flatten the fabric (long strip attached). The ironing board is part
of the screen case. Do not remove. Contact Da-Lite if the ironing
board is in need of adjustment. (Fig. 2).
Shipping
Brace
(Not on 3"
Roller)
3. Place a third hanger on the center line of fabric.
4. On screens equipped with an ironing board, make sure
hangers do not interfere with the ironing board brackets.
5. Make sure hanger used on motor end does not interfere
with motor access door.
Ceiling Type
Hanger
Recessed Above Ceiling
Picture
Other methods of installation will no doubt
Surface
suggest themselves especially in new buildings
where it would be an easy matter to provide a
recess for the screen to conceal it when not in use.
Do Not Seal In-Allow Access.
For Exposed Installation
If the screen is to be mounted in an exposed
position, it may be covered with finished plywood,
veneer paneling, plastic wall covering or a valance.
Hex Head
Screws
Figure 2
Ironing
Board
Rafters
Picture Surface
Tape Strip