Da-Lite Cosmopolitan Electrol Книга инструкций - Страница 11

Просмотреть онлайн или скачать pdf Книга инструкций для Аксессуары для проекторов Da-Lite Cosmopolitan Electrol. Da-Lite Cosmopolitan Electrol 16 страниц. For sizes up to 9'x12'
Также для Da-Lite Cosmopolitan Electrol: Книга инструкций (8 страниц), Книга инструкций (8 страниц), Книга инструкций (8 страниц), Книга инструкций (6 страниц), Книга инструкций (6 страниц), Книга инструкций (8 страниц)

Печатать страницу
Da-Lite Cosmopolitan Electrol Книга инструкций
Optional Built-In Video Projector Interface
CAUTION: The projector must be turned off before
connecting the trigger wires to the projector. Failure to do so
may damage the controller.
ATTENTION: Le projecteur doit être éteint avant de brancher
les fils de déclenchement à celui-ci. Tout manquement à
cette instruction pourrait endommager le contrôleur.
Use 2-conductor 18–24 gauge wire to extend the low voltage
connection from the projector's 5 or 12-volt screen trigger output to
the length required to reach the VPI.
NOTE: When extending the low voltage connection from the
projector's screen trigger output polarity does not matter. The red
and black wires from the VPI are interchangeable.
RJ-22 Jack
(Connection to
Wall Switch)
VPI Trigger
Module
Black
Red
5/12 Volt
Screen Trigger
on Projector
IMPORTANT NOTE: The wall switch is REQUIRED to make any limit
switch adjustments, EVEN if a third party control system is used.
Therefore, it is advised to wire the switch or provide a 3-conductor
connection that is accessible.
3-conductor 20–24 gauge wire can be used in place of the supplied
RJ-14 cable to connect the wall switch. Connect the BUS terminals on
U P
the wall switch to the corresponding BUS terminals on the splitter
S T O
P
board.
D O
W N
See 120V or 220V wiring diagram with built-in low voltage
control for complete wiring instructions.
RJ-22
Jack (QEYE)
11