Da-Lite Dual Masking Electrol Книга инструкций - Страница 5

Просмотреть онлайн или скачать pdf Книга инструкций для Аксессуары для проекторов Da-Lite Dual Masking Electrol. Da-Lite Dual Masking Electrol 8 страниц.

Печатать страницу

Screen Adjustment For 220/240V Screens

CAUTION! The mask should not be field adjusted for more or less drop.

ATTENTION! Le masque ne doit pas être ajusté sur place pour régler la chute.

Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite.

Should it be necessary to adjust for more or less drop of picture, proceed in the following manner:

NOTE: Use a screw driver or allen wrench to make adjustments.

More screen drop

Remove access panel (Fig. 1).

2. Place operating switch in "down" position.

3. When the screen stops, turn the "down" limit knob (Fig. 2)

one-quarter turn counterclockwise. Test by raising picture

surface approximately two feet, then lower again. Repeat

until desired picture surface position is attained.

NOTE: Must leave 1-1/2 wraps of fabric on roller!

4. Replace access panel.

Dual Masking Electrol

220 / 240V Wiring Diagram

Instructions

Brown

Down

Black

Common

Blue

Ground

Green

4 – Wire

Mask Motor

Less screen drop

Remove access panel. (Fig. 1).

2. Raise picture surface approximately two feet

above desired level.

3. Place operating switch in "off" position.

4. Turn the "down" limit knob (Fig. 2) one-quarter turn

clockwise. Test by raising picture surface approximately

two feet, then lower again. Repeat until desired picture

surface position is attained.

5. Replace access panel.

Mask

Screen

Off

Down

Brown

Down

Black

Common

Blue

Ground

Green

4 – Wire

Screen Motor

220/240 V. AC 50 Cycle

Brown (Hot)

Blue (Common)

Ground Wire