Da-Lite TENSIONED CONTOUR ELECTROL Книга инструкций - Страница 3
Просмотреть онлайн или скачать pdf Книга инструкций для Аксессуары для проекторов Da-Lite TENSIONED CONTOUR ELECTROL. Da-Lite TENSIONED CONTOUR ELECTROL 9 страниц. Installer friendly features
Также для Da-Lite TENSIONED CONTOUR ELECTROL: Книга инструкций (13 страниц), Руководство монтажника (2 страниц), Руководство по эксплуатации (9 страниц), Книга инструкций (13 страниц)
Печатать страницу
INSTALLATION
Carefully unpack screen and remove outer wrapping from
case.
Remove the retaining screws (through back of case) from
the slat bar before the case is installed.
There are three ways to install the Tensioned Contour
electrol
: Wall mount, Ceiling mount, or Ceiling hook.
®
Procedures for each method are as follows:
Wall Mount
1. secure the wall mount bracket to the wall at the
desired height. bracket should be fastened to wall
studs or some reinforcement within the wall. Concrete
or brick walls require special fasteners and anchors.
2. make sure the bracket is level. see figure 1 for
reference dimensions.
3. keep in mind you will need at least 2-3/8" between the
ceiling and the top of the wall mount bracket to be
able to position the case on the bracket.
4. mount the screen case on the wall bracket as shown
in figure 1. be sure the case is fully seated on the
bracket. Tighten the stop screws against the wall
bracket.
Ceiling Mount
1. do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural
stability to the case.
2. be sure the ceiling has adequate reinforcement to
attach the screen brackets.
3. The top of the screen case has two channels with
threaded nuts that slide the length of the case. attach
two ceiling mount brackets to the screen case as
shown in figure 2. mount cannot be more than 12"
from end of case.
4. hold the screen case up to the ceiling and mark the
hole locations. The brackets have a set of front holes
and a set of rear holes. It is best to use at least one
hole in each set.
Ceiling Hook
1. do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural
stability to the case.
2. be sure the ceiling has adequate reinforcement to
attach a hook anchor.
3. The top of the screen case has two channels with
threaded nuts that slide the length of the case. attach
ceiling hook brackets as provided to the screen case
as shown in figure 3.
4. The brackets can be attached anywhere within 12" of
the end of the case.
5. attach an s-hook or similar fastener to the hole in the
bracket.
®
6-3/8"
2
5-11/16"
2-5/16"
Case
hook
Wall
mounT
bRaCkeT
sToP sCReW
FIGURE 1
1/4 x 5/8" flaT
head sCReW
FIGURE 2
CeIlIng hook bRaCkeT
1/4 x 5/8" flaT
head sCReW
FIGURE 3
2-9/16"
CeIlIng
mounT
bRaCkeT