eKey Home Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Шлюз eKey Home. eKey Home 20 страниц.
Также для eKey Home: Руководство по эксплуатации (17 страниц)

Печатать страницу
ENGLISH
to
to
7.1.3
INITIAL START-UP:
CONNECTION BETWEEN THE CONTROL PANEL AND THE FINGER SCANNER
When the devices are connected to the power supply the display starts to count down until a connection has been
created with the finger scanner. Afterwards two red dots appear. During this time the status display on the finger
scanner lights up red. Once the start procedure has been completed the status display begins to flash orange. Now the
initialisation can be started.
Please press the OK button followed by the ESC button. "EF" appears on the display, which stands for "Enroll Finger".
A pre-recorded finger may now be swiped over the sensor and the initialisation process is started without deleting any
files. If no fingerprints have yet been recorded (new installation) then the initialisation process can be ended by
pressing the ESC button.
The initialisation process runs completely automatically, in the course of which the devices are connected with each
other. This connection is meant to prevent unauthorised people gaining access in case of an improper exchange of a
finger scanner.
After the initialisation the flashing dot on the display of the control panel signalises normal mode. The security code is
preset to the standard value of 99. Please change this as soon as possible to a two-digit security code of your choice.
7.1.4
OVERVIEW OF THE PROGRAMMING MENU OF THE CONTROL PANEL:
You can access lower menu levels by pressing the OK button. You can move back up by pressing the ESC button. You
can navigate or choose an option by pressing the < and > buttons for left and right respectively.
"Nu" - Need Update
"E0"- Error code
"E1"-Error code
"E2"-Error code
"E3"-Error code
Display
of
a
number
between "1" and "99"
plus the dot on the right
is lit up.
Control
panel
counts
down from "44" to "0"
This terminal requires a firmware update. This display also
appears during updating.
There is no connection to the finger scanner, or the energy
supply to the system has been interrupted. The system will be
restarted.
99 fingerprints have already been registered
No more fingerprints can be registered. Where necessary
delete existing fingerprints in order to record new ones.
30min-lock
after
the
incorrectly three times. Wait 30 minutes before entering the
security code again.
Devices connected incorrectly. Connect the devices again, as
one of the devices has been manipulated.
Shows the user number of the recognised fingerprint.
State when connected to live current, with no connection
having been created to the finger scanner. If the control panel
does not switch to normal mode after a few seconds, but
continues to count down, the connection with the finger
scanner is not intact and has to be checked.
security
code
has
been
entered