EKKO EA15C Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Вилочные погрузчики EKKO EA15C. EKKO EA15C 10 страниц. Semi-electric fork-over stacker

Печатать страницу
Plug the charger into any 110V outlet, then plug the charger into the unit of the
recharging socket. It will automatically stop charging when the charge is
complete.

4. Troubleshooting

No
Trouble
1
The forks cannot lift to the
max. height.
2
The forks cannot lift at all.
3
Does not power up.
4
The
forks
lowered.
5
Leaks
The fork descends by itself
6
7
Battery will not be charge
Note: Without authorization or training, it is strictly prohibited
to repair the Stacker!
-Low on hydraulic fluid
-No hydraulic fluid.
-The tank or fluid has impurities.
-The emergency switch is pressed
down.
-The battery is too low.
-The electrical wiring connectors
are loose.
-The contact of DC motor is bad.
-The piston rod or mast is
malformed resulting from partial
loading slanting to one side or
over-loading.
cannot
be
-The forks were kept in an
elevated position for long time
with piston rod bare which
resulted in rusting and jamming
of the rod.
-The pump release valve is not
open.
-Seals appear worn and/or
damaged.
-The impurities in the fluid
caused the release valve not
properly seal shut.
-Sealing parts worn or damaged.
-The release valve is damaged.
-Battery is bad.
-The charging plug is loose.
Cause
-Add hydraulic fluid.
-Add hydraulic fluid.
-Change fluid.
-Pull emergency switch up.
-Charge the unit.
-Tighten the bolts.
-Replace with new one.
- Replace it with a new one.
-Keep the forks in the lowest
-Check it, if damaged, replace
-Replace with the new one.
-Replace it with new oil.
-Replace it with a new one.
-Replace with the new one.
- Replace it with a new one.
- Tighten the clamps or bolts
- 6 -
Solution
possible position if not in use and
pay more attention to lubricating
the piston rod.
with new one.