American Time SiteSync IQ Руководство по установке и эксплуатации - Страница 5

Wireless Tone Generator

The wireless tone generator will allow the user to activate tones wirelessly and interface with power

and audio amplifier wiring through a screw terminal located in the bottom panel of the wireless tone

generator. See the figure below.

WARNING: Never apply electrical power to this device until wiring is completed and in accordance

with all local and national electrical codes.

Amp

COM

The two left most terminals on the wireless tone generator's larger terminal block are labeled

TO AMP COM | SIG OUT. These terminals should be connected to the amplifier system/receiver.

The next used terminal is labeled TONE SELECT

(COMMON). This terminal is used to complete the tone

selection circuit. It will be connected using the supplied

jumper wire to one or two of the T1, T2, T3 or T4 terminals

depending on which tone is preferred. The Tone Selection

Table (at right) documents which T1, T2, T3 or T4 terminals

should be connected to the TONE SELECT (COMMON).

Example: If you want a 333 Hz tone with three repeated

pulses, you would wire the TONE SELECT (COMMON)

terminal to T1 and T3.

The smaller terminal strip (on the right) is where the Hot,

Neutral and Ground power inputs are to be connected. These should be connected with no electrical

power supplied and following all local and national electrical codes.

Tone

Select

Output

Operation

Earth Ground

AC Return

120vac