Astonica 40201116 Руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Открытый фонтан Astonica 40201116. Astonica 40201116 2 страницы. 2-tier brushed bronze bucket accent fountain
Печатать страницу
PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Pump
Handle
B
Pump Spout
C
Small Platform
D
Large Platform
E
Small Tub
F
Large Tub
G
Clear Tube
H
Large Screw
I
Small Screw
J
Electric Pump
K
Medium Screw
L
Support Post
Parts Detail
A
B
E
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ELECTRICAL SAFETY INSTRUCTIONS
WARNING!
ELECTRICAL SHOCK. Read and understand all instructions. Failure to follow all
instructions listed below, may result in electrical shock, fire and/or serious personal injury.
Grounding Instructions
This fountain must be plugged into a 3-wire, 3-prong outlet that is properly working and has
been installed and grounded in accordance with all local, state or federal codes and ordinances.
DANGER:
IMPROPER INSTALLATION OF THE GROUNDING PLUG CAN RESULT IN A RISK OF
ELECTRICAL SHOCK. Check with a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt as to weather the product is properly grounded. Do not
modify the plug provided; if it will not fit the outlet, have a proper outlet installed by a qualified
electrician. Do not use any type of adapter with this product.
Outdoor Use Extension Cords.
1. When product is used outdoors, use only extension cords marked for outdoor use.
2. Use only UL listed extension cords. Never use damaged or altered extension cords.
3. Follow extension cord manufacturer safety instruction.
Extension Cords
1. Make sure your extension cord is in good condition.
2. When using extension cords, be sure to use one heavy enough to carry the current your product
requires. An undersized cord will cause a drop in line voltage resulting in power loss and
overheating. Reference Table 1 on the bottom of next page for the correct size to use depending
on cord length and nameplate Ampere rating. If in doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord.
QUANTITY
C
D
J
H
I
K
F
1
CAUTION: Do not over tighten fasteners.
1
1. (SEE FIGURE 1) Attach the small platform (C)
1
to smal tub (E) using medium screw (K) as
1
shown. Attach small tub (E) to the large
1
platform (D) using small screw (I) as shown.
1
1
2
3
2. (SEE FIGURE 2) Attach support post (L) to the
2
underneath of the large platform (D). Attach
1
the large platform (D) to the large tub (F)
8
using medium screws (K) in 4 places as
1
shown.
G
3. (SEE FIGURE 3) Attach the pump spout (B) to
small platform (C) using large screws (H)
and medium screws (K) in four places as shown.
Attach pump handle (A) to pump spout (B)
using one medium screw (K).
L
4. (SEE FIGURE 4) Attach the clear tube (G) to
bottom of the pump spout (B) and place the
other end of the clear tube through the bottom
of the small tub (E) and large platform (D).
Attach the end of the clear tube (G) to the
electric pump (J) at the opening on the top
of the pump as shown.
Table 1. Minimum Recommended
Extension Cord Gauge (AWG) Chart
AMP Load
120V
AWG
1-5
6-10
10-12
12-16
ASSEMBLY INSTRUCTIONS
Figure 1
Figure 2
L
Figure 3
Figure 4
Volts Extension Cord Length
25'
50'
100'
150'
18
16
16
14
18
16
14
12
14
14
14
12
14
12
Not recommended
2
K
C
E
I
D
K
C
E
K
F
H
A
B
K
K
H
H
C
E
F
B
E
J
G