astra telematics AT100 Руководство по быстрой установке

Просмотреть онлайн или скачать pdf Руководство по быстрой установке для GPS astra telematics AT100. astra telematics AT100 2 страницы.

AT100 Quick Installation Guide

1. Install the GSM SIM card

Insert the SIM card into the small slot in the side of the AT100, until it is flush with the edge of

the case. Correct orientation of the SIM card is important for correct operation and to avoid

damage to the SIM – see below:

2. Protect SIM card

Once the SIM is installed, it is advisable to cover the SIM slot with tape or an anti-tamper

label, to protect against ingress of dirt and deter tampering.

3. Power Supply

The AT100 should be connected to a permanent power source - voltage range 6 to 30 VDC,

with a 1.0A in-line fuse, fitted to both POSITIVE and GND feeds. If using CB001 Power

Cable, hook up the RED and BLACK wires appropriately.

4. Ignition Sense Input

The white IGN SENSE wire included in the standard CB001 power loom is used to sense the

vehicle's ignition state. This wire must be connected to a source which goes high (12/24V)

only when the vehicle ignition is on. In line resistors are NOT REQUIRED.

5. Additional inputs/PTOs

If additional inputs (PTOs) are required, fit a CB004 or CB005 cable to the 36 way data

connector and connect the appropriate inputs as necessary. No ground return is necessary,

as the ground is common with the power source. In line resistors are NOT REQUIRED. No

wires should be shorted together and unused wires should be insulated.

Signal

Digjtal 1 – IGNITION

Digital 2 – PANIC BUTTON

Digital 3

Digital 4

Digital 5

Digital 6

ADC INPUT

CB004 Cable

CB005 Cable

WHITE

ORANGE

CYAN

PURPLE

RED

BROWN

PINK

YELLOW

ORANGE

GREEN

BLACK

RED

BROWN

N/A