Ameritool 4" TRIM SAW Инструкции - Страница 2

Просмотреть онлайн или скачать pdf Инструкции для Пила Ameritool 4" TRIM SAW. Ameritool 4" TRIM SAW 2 страницы.

7. Place the material to be cut on the saw table and line it up properly with the

diamond blade. Slide the material lightly into the blade until a groove forms; then

firmly push the material slowly through the blade. Remember, the saw will only

cut in a straight line. Do not attempt to cut curves. The diamond blade works

best when material is pushed firmly against it. However, NEVER force a

diamond blade.

8. Material to be cut should never be more than 2/3 the size of the visible cutting

area of the blade. Do not attempt to cut soft material such as wood with a

diamond blade; do not cut any material with hardness less than a common

building brick. The diamond saw blade will actually cut hard materials much

easier than soft materials as soft materials tend to clog up the microscopic

diamond particles.

9. When working with several pieces of material, be sure to replenish the water as

needed to prevent cutting dry.

10. As you near the end of the cut, reduce pressure on the material. This will avoid a

sudden "break-through" and give a cleaner cut.

11. When work is completed, turn off switch and unplug Trim Saw. Drain water

from sump, drying machine and blade with paper towels or an old cloth. Briefly

turn on Trim Saw to spin dry the blade thoroughly.

• Be sure to dry saw and blade after each use to prevent rust to the blade.

• If the saw is stored with water in the sump, (not recommended!) be sure to lower

the water level so that it is below the blade. Otherwise, the blade will rust.

• The saw arbor and the shaft it fits on are made from different materials; and over

time they can galvanize together making it impossible to remove the arbor. Every

2 months or so, remove the arbor using the allen wrench, turning counter

clockwise. Place a few drops of oil on the shaft, rubbing to coat the shaft lightly.

Then replace the arbor using the allen wrench to tighten.

• Important: Take care not to get any oil or water down the shaft and into the

motor, as this will cause the motor to burn out.

• Do not pour the used water down the drain as it can harden like cement, closing

up the drain.

MAINTENANCE

AMERITOOL, INC.

915 Merchant Street

Suite 3

Redding, CA 96002

Phone: (530) 223-2031

Fax: (530) 223-2639

www.ameritool-inc.com