Doorentryonline SR2-X Руководство пользователя - Страница 11

Просмотреть онлайн или скачать pdf Руководство пользователя для Устройство для чтения карт Doorentryonline SR2-X. Doorentryonline SR2-X 12 страниц. Proximity, wiegand & mifare card reader with remote control

Печатать страницу

Set Strike-out Alarm

The strike-our alarm will sound after 10 failed card attempts (Default setting is OFF). It can be set to deny

access for 10 minutes after engaging or disengage only after entering a valid card/PIN or Master Code/Card

Programming Step

1. Enter Program Mode

2. Strike-Out OFF

3. Strike-Out ON

4. Strike-Out ON (Alarm) Set alarm time

5. Exit Program Mode

Set Audible and Visual Response Via the Remote Control

Programming Step

1. Enter Program Mode

2. Control tone sounds

3. Control LED's

4. Exit Program Mode

Reset Procedure

Reset Alarm:

The alarm will sound for 3 minutes. To reset, present a valid user card or enter * (Master Code) # via the

remote control

Reset to Factory Default:

To reset to factory default, power off, press the Exit Button or short circuit the Black (GND) and Yellow (Open)

wires, and then power on, there will be two bleeps, and the LED light will turn orange, keep this condition until

you hear a long bleep after 10 seconds. The LED will turn red to confirm factory default is successful

Note: Reset to factory default, the user's card/key fob information is still retained

Reset to Factory Default to add a new Master Card:

To reset to factory default, power off, press the Exit Button, or short circuit the Black (GND) and Yellow (Open)

wires, and then power on, there will be two bleeps, and the LED light will turn orange

Release the exit button or the Black (GND) and Yellow (Open) wires, then present any 125KHz EM or 13.56MHz

card or key fob and the LED will turn red to confirm factory default is successful

Note: Reset to factory default, the user's card/key fob information is still retained

Remote Control Operation

* (Master Code) #

60# (Factory default is OFF)

61# Access is denied for 10 minutes

62#, 5 (0-3) # (Factory default is 1 minute) Enter Master Code

# or present the Master Card or enter valid user card/PIN to silence

Remote Control Operation

* (Master Code) #

OFF = 70 #

ON = 71 #

OFF = 72 #

ON = 73 #

(Factory default is ON)