DoorHan SHAFT-30 Руководство по установке и эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Открыватель ворот DoorHan SHAFT-30. DoorHan SHAFT-30 12 страниц. Ip65/60 ip65
Также для DoorHan SHAFT-30: Руководство по установке (8 страниц), Руководство (12 страниц)
Печатать страницу
5.2. OPEN POSITION (GREEN CAM)
Coarse adjustment
Make sure, that the operator is fixed rigidly; put the door in fully closed position.
•
•
Loosen the screw for coarse adjustment of green cam, then turn it so, that the microswitches are pushed, then tighten
the screw.
Close and open the door, make sure, that the green cam pushes the microswitches and DL2 indicator goes off on the control
•
block.
Fine adjustment
•
Turning the fine adjustment screw, adjust the closed position of the door.
•
Clockwise turning of the screw causes earlier actuation of the limit switch; counterclockwise turning of the screw causes
later actuation of the limit switch.
•
Open and close the door, make sure, that the green cam pushes the microswitches and the door stops in the required position.
WARNING! When the end positions are adjusted, make sure, that the limit switches work properly: after pushing the cam
the relative indicator on the control unit should go out. If the indicator still glows, repeat adjustment.
Сams. Top view
Сams. Side view
Microswitch
Fine adjustment
screw
ADJUSTMENT OF EXTREME POSITIONS
Coarse adjustment
screw
Additional cam for accessories connection
(traffic light, alarm system, etc.) (yellow)
7