Canon PIXMA MP500 Инструкция по установке - Страница 4

Просмотреть онлайн или скачать pdf Инструкция по установке для Принтер "все в одном Canon PIXMA MP500. Canon PIXMA MP500 9 страниц. Continuous ink supply system
Также для Canon PIXMA MP500: Технический паспорт (2 страниц), Начните здесь (2 страниц), Дополнительное руководство (6 страниц), Краткое руководство по эксплуатации (39 страниц), Краткое руководство по эксплуатации (2 страниц)

Do not allow the ink levels to fall below the refill line. To refill each ink simply remove the air filter

and replace the travel plugs(to prevent the air balance chambers filling with ink)for the color in

which you are refilling.

b) Remove the filler plug and carefully pour or syringe the correct color ink into the appropriate ink reservoir.

Please ensure to double check the color with the sticker located on the bottle and the top of the tank.

c) Replace the filler plug once filled. Remove the small travel plug replacing it with the air filter.

5. Cartridge chip disable-low ink

When the printer show the ink level is low, please turn off and turn on the printer to reset the cartridge, if it is not

reset, please take out the cartridge and put back in to reset the cartridge ink level.

6. Trouble shooting

Please contact us if any of the following trouble shooting suggestions do not fix your problems.

a) Leaking Ink

If your ciss appears to be leaking from the cartridges, please ensure that you put reservoir on the same

table with printer without anything under it. The CISS works on a vacuum and if raised gravity will take over

and flood you printer. Ensure that you installed the silicone seals as section 5) of this manual. Failure to

install the seals can result in ink seepage.

Poor print quality

a) Bad print nozzle check.

If you are having problems when performing nozzle checks please ensure that the small silicone seals have

not moved out of place when inserting the cartridges. They must no be interfering with the print head.

Not enough ink!

1)If you are finding that colors seem to be missing or are printing poorly please ensure that you have

placed the air valves into the travel plug holes

2)If your unit has excess air in the silicone tubing please perform a deep head clean followed by a nozzle

check. If this does no remove the air from the tubing please refer to the priming instructions

Too much ink!

1) Please ensure that you do not have your ink reservoir placed higher than the printer level. The CISS

works on a vacuum and if raised higher than the printer head, gravity will take over and flood you printer

2) Check your printer settings to ensure you have the correct setting for the paper you are using. If you

choose photo paper when using plain paper or vice versa the print will be affected as these settings

determine the amount of ink dispersed onto the paper.