Astralpool Jetstream Руководство по установке и эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Пылесос для плавательных бассейнов Astralpool Jetstream. Astralpool Jetstream 10 страниц.
Печатать страницу
4. Remove the filter bag from the support bars (Fig 14), turn inside out and wash off all the dirt with a garden
hose or in a sink. Squeeze the bag gently until the rinse water is clear. If necessary, machine wash the
bag using only cold water with NO DETERGENT!
5. Re-install the bag on the support bars with the label in the centre of one of the long sides of the bottom lid
(Fig 15)
6. Re-install the bottom lid assembly in the body. Push down on it until the lock tabs will snap into place
properly.
SETTING THE CLEANING PATTERN
Your Jetstream robotic pool cleaner uses a systematic cleaning pattern that allows the cleaner to go back and
forth in overlapping patters. The cleaner may be used to clean a variety of different size pools. Before its first use,
you must set the cleaner up for your pool. To adjust the cleaner you will use the axle locking pin (Fig 17)
permanently attached to the unit with a lanyard.
For most pools ranging from 24m to 27m in length, the cleaner has to be set to look like the picture in Fig 16 with
the lock pin installed in the rear position. The cleaner will clean the pool in a consistent pattern. To increase the
turning radius, the lock pin can be moved into the forward position (Fig 18).
After your cleaner completes its cycle, remove the cleaner from the pool and transfer the lock pin to the opposite
side of the axel. By doing this, the next time your cleaner is put into the pool it will work in the opposite pattern to
ensure the best coverage of the pool floor.
Inst308 Jetstream Robotic Pool Cleaner Instructions V.08_12
7