Doosan HM 5000 Устранение неисправностей Atc - Страница 4

Просмотреть онлайн или скачать pdf Устранение неисправностей Atc для Промышленное оборудование Doosan HM 5000. Doosan HM 5000 16 страниц.

HM 5000/6300/8000

4) Press the MANUAL soft key from the bottom soft key

bar.

☞ The "ATC APC Manual Switch" screen appears.

5) Press the ATC-ON soft key from the bottom soft key

bar.

☞ From the "ATC APC Manual Switch" screen, you

will notice that the "ATC Manual Mode" is turned

on.

6) Depending on the operation that you want to perform, select "TOOL CHANGE STEP REVERSE"

(6-1), (6-3) or "TOOL CHANGE STEP FORWARD" (6-2).

6-1) If the changer arm is stuck while trying to pull out a tool from the spindle

Turn the mode selection switch in the ATC manual OP to "TOOL CHANGE STEP REVERSE".

☞ If the machine is in the state of tool unclamping, manually perform the tool clamping before

proceeding.

▪ How to confirm the state of tool unclamping: Check if the spindle emits the collet air (in MDI

or Auto mode), or check if the button indicator of Tool Unclamp on the manual OP turns

on.

6-2) If the changer arm is stuck in the spindle after changing a tool

Turn the mode selection switch in the ATC manual OP to "TOOL CHANGE STEP FORWARD".

6-3) If the changer arm has stopped operation irrelevantly to the spindle (in the state of

Spindle Unclamp)

Turn the mode selection switch in the ATC manual OP to "TOOL CHANGE STEP REVERSE".

HM4digitATCE26