Ames Instruments 63985 Руководство пользователя и инструкции по безопасности - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя и инструкции по безопасности для Термометр Ames Instruments 63985. Ames Instruments 63985 8 страниц.
Печатать страницу
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
General Operation
Note: Do not expose Thermometer to strong electromagnetic fields, such
as those generated by an arc welder, induction heater, etc.
Note: When moving Thermometer to an area with significantly different ambient temperature,
allow Thermometer to adjust to the new ambient temperature for 30 minutes before use.
The object being tested should be larger than the size calculated by the diagram below.
1. Remove dirt and grime from surface
to be measure as needed.
2. Adjust Emissivity as needed.
Note: Black electrical tape or black paint may
be applied to highly reflective surfaces to raise
emissivity. Leave Thermometer set to 0.95 and
allow tape or paint to come to same temperature
as surface before taking measurement.
3. Hold Thermometer and point
it toward surface.
Page 6
1"
diameter
at 1'
distance
For technical questions, please call 1-888-866-5797.
Distance
2"
diameter
at 2'
distance
4. Press and hold Trigger, pointing Laser
at surface. When SCAN appears on
Display, testing is in progress.
5. Read Measurement.
6. Release Trigger,
on Display and reading will be
held for several seconds.
Note: Thermometer will shut off
after 20 seconds of non-use.
Spot
Center
4"
diameter
at 4'
distance
HOLD
will appear
Item 63985