Acer AcerSystem Руководство пользователя - Страница 20

Просмотреть онлайн или скачать pdf Руководство пользователя для Настольный компьютер Acer AcerSystem. Acer AcerSystem 32 страницы. Acer aspire z3761 21.5 pw.sh0e2.011
Также для Acer AcerSystem: Руководство пользователя (27 страниц), Руководство пользователя (16 страниц), Руководство пользователя (41 страниц), Руководство пользователя (17 страниц), Руководство пользователя (27 страниц), Руководство пользователя (30 страниц), Руководство пользователя (36 страниц), Руководство пользователя (30 страниц), Руководство пользователя (41 страниц), Руководство пользователя (28 страниц), Руководство пользователя (32 страниц), Руководство пользователя (на английском языке) (43 страниц), (Португальский) Руководство пользователя (41 страниц)

Печатать страницу
Acer AcerSystem Руководство пользователя
10

Frequently asked questions

The following questions are possible situations that may arise during
the use of your computer and each is followed by easy answers and
solutions to the situation.
Q: I pressed the power switch but the system did not boot up.
A: Check the LED located above the power switch.
If the LED is not lit, no power is being applied to the system. Do any of
the following:
•
Check if the voltage selector switch located on the rear panel of
the computer is set to the correct voltage.
•
Check if you plugged the power cable properly into an electrical
outlet.
•
If you are using a power strip or AVR, make sure that it is plugged
in and turned on.
If the LED is lit, check the following:
•
Is a non-bootable (non-system) diskette in the floppy drive? If yes,
remove or replace it with a system diskette and press Ctrl + Alt +
Del to restart your computer.
The operating system files may be damaged or missing. Insert the
•
start-up disk you created during Windows setup into the floppy
drive and press Ctrl + Alt + Del to restart your computer. This will
automatically diagnose your system and make necessary fixes.
However, if the diagnostic utility still reports a problem, then you
may have to perform the recovery process to restore your system
to its original default factory settings.
Note: For more information about recovering your system,
refers to the RCD instruction sheet.
Q: Nothing appears on the screen.
A: Your computer's power management function automatically blanks
the screen to save power. Just press any key to turn the display back
on.
If pressing a key does not work, you can restart your computer. If
restarting your computer does not work, contact your dealer or the
technical support center for assistance.